Home › ADAS / AD › ADVANCED PARK › ADVANCED PARK › from 2021.07
RM3700E _95 ADAS / AD _105827 ADVANCED PARK _0485712 ADVANCED PARK U

ADVANCED PARK  ADVANCED PARK  TERMINALS OF ECU  


CLEARANCE WARNING ECU ASSEMBLY


E220917E99
3.375,0.219 3.74,0.458 0.365,0.24 3.427,0.25 3.885,0.448 0.458,0.198 10 false O60

a.

Disconnect the O60 clearance warning ECU assembly connector.


b.

Measure the voltage and resistance on the wire harness side connector according to the value(s) in the table below.

Terminal No. (Symbol) Terminal Description Condition Specified Condition
O60-1 (IG) - O60-31 (E) IG power source signal Ignition switch off Below 1 V
Ignition switch ON 11 to 14 V
O60-11 (ISSW) - Body ground Combination switch assembly (advanced park main switch) signal
·

Ignition switch ON

·

Combination switch assembly (advanced park main switch) off


Below 1 V
·

Ignition switch ON

·

Combination switch assembly (advanced park main switch) on


11 to 14 V
O60-31 (E) - Body ground Ground Always Below 1 Ω


c.

Reconnect the O60 clearance warning ECU assembly connector.


d.

Measure the voltage and resistance and check for pulses according to the value(s) in the table below.

Terminal No. (Symbol) Terminal Description Condition Specified Condition
O60-2 (BOF) - O60-31 (E) Power source for front sensor circuit Ignition switch off Below 1 V
·

Ignition switch ON

·

Intuitive parking assist system on


11 to 14 V
O60-3 (E5) - O60-31 (E) Ground for front clearance sonar Always Below 1 Ω
O60-4 (SOF) - O60-31 (E) Front sensor communication signal (Front clearance sonar sensor)
·

Ignition switch ON

·

Intuitive parking assist system on

·

Shift lever in any position other than P

·

Vehicle speed less than approximately 10 km/h (6 mph)


Pulse generation
(Refer to waveform 1)
O60-9 (CBZ) - O60-8 (EF) No. 1 clearance warning buzzer signal Buzzer sounding Pulse generation
(Refer to waveform 2)
O60-19 (BOR) - O60-31 (E) Power source for rear sensor circuit Ignition switch off Below 1 V
·

Ignition switch ON

·

Intuitive parking assist system on


11 to 14 V
O60-20 (E1) - O60-31 (E) Ground for rear clearance sonar Always Below 1 Ω
O60-21 (SOR) - O60-31 (E) Rear sensor communication signal (Rear clearance sonar sensor)
·

Ignition switch ON

·

Intuitive parking assist system on

·

Shift lever in R


Pulse generation
(Refer to waveform 3)


e.

Using an oscilloscope, check waveform 1.

i.
E456275N01
0.167,1.229 0.625,1.427 0.458,0.198 10 false GND

Waveform 1 (Reference)

Item Content
Measurement terminal O60-4 (SOF) - O60-31 (E)
Measurement setting 5 V/DIV., 100 μs./DIV.
Condition
·

Ignition switch ON

·

Toyota parking assist-sensor system (w/ Parking Support Brake System)

·

Shift lever in any position other than P

·

Vehicle speed less than approximately 10 km/h (6 mph)





f.

Using an oscilloscope, check waveform 2.

i.
E227014N05
0.083,1.677 0.552,1.938 0.469,0.26 10 GND

Waveform 2 (Reference)

Item Content
Measurement terminal O60-9 (CBZ) - O60-8 (EF)
Measurement setting 2 V/DIV., 500 μs./DIV.
Condition Buzzer sounding

HINT:

The amplitude of the waveform changes according to the set volume.




g.

Using an oscilloscope, check waveform 3.

i.
E456275N01
0.167,1.229 0.625,1.427 0.458,0.198 10 false GND

Waveform 3 (Reference)

Item Content
Measurement terminal O60-21 (SOR) - O60-31 (E)
Measurement setting 5 V/DIV., 100 μs./DIV.
Condition
·

Ignition switch ON

·

Toyota parking assist-sensor system (w/ Parking Support Brake System)

·

Shift lever in R