Home › Audio / Visual / Telematics › PARK ASSIST / MONITORING › TOYOTA PARKING ASSIST-SENSOR SYSTEM (w/ Parking Support Brake System) › from 2021.07
RM3700E _56 Audio / Visual / Telematics _093031 PARK ASSIST / MONITORING _0485733 TOYOTA PARKING ASSIST-SENSOR SYSTEM(w/ Parking Support Brake System) J

PARK ASSIST / MONITORING  TOYOTA PARKING ASSIST-SENSOR SYSTEM(w/ Parking Support Brake System)  Clearance Warning ECU Power Source Circuit  


DESCRIPTION

This circuit provides power to operate the clearance warning ECU assembly.

WIRING DIAGRAM

E384449E11
5.271,1.583 5.583,1.781 0.313,0.198 10 false O60 5.271,1.781 6.802,2.229 1.531,0.448 10 false Clearance Warning ECU Assembly 5.448,1.198 5.604,1.396 0.156,0.198 10 false E 5.208,1.094 5.521,1.292 0.313,0.198 10 false 31 5.24,0.74 5.552,0.938 0.313,0.198 10 false 1 5.458,0.885 5.771,1.083 0.313,0.198 10 false IG 2.594,0.479 3.729,0.719 1.135,0.24 10 false ECU-IGR NO. 1 0.583,0.281 1.979,0.563 1.396,0.281 10 false from IGR-NO. 1 Relay 0.115,2.188 2.49,2.417 2.375,0.229 10 false *1: w/o Stop and Start System 0.104,2.49 2.313,2.677 2.208,0.188 10 false *2: w/ Stop and Start System 0.531,0.854 1.906,1.229 1.375,0.375 10 false from Engine Stop and Start ECU 3.708,0.167 4.021,0.365 0.313,0.198 10 false *1 3.688,0.76 4,0.958 0.313,0.198 10 false *2

CAUTION / NOTICE / HINT

NOTICE:

Inspect the fuses for circuits related to this system before performing the following procedure.


PROCEDURE

1.CHECK HARNESS AND CONNECTOR (CLEARANCE WARNING ECU ASSEMBLY - BATTERY AND BODY GROUND)
a.

Disconnect the O60 clearance warning ECU assembly connector.


b.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition

Click Location & Routing(O60)Location & Routing

Click Connector(O60)Body>Floor Wire>Clearance Warning ECU Assembly

O60-31 (E) - Body ground Always Below 1 Ω



c.

Measure the voltage according to the value(s) in the table below.

Standard Voltage:
Tester Connection Switch Condition Specified Condition

Click Location & Routing(O60)Location & Routing

Click Connector(O60)Body>Floor Wire>Clearance Warning ECU Assembly

O60-1 (IG) - Body ground Ignition switch ON 11 to 14 V *1
10.5 to 16 V *2
O60-1 (IG) - Body ground Ignition switch off Below 1 V


*1: w/o Stop and Start System

*2: w/ Stop and Start System



Result:
Result Proceed to
OK A
NG (w/o Stop and Start System) B
NG (w/ Stop and Start System) C



A

B

REPAIR OR REPLACE HARNESS OR CONNECTOR

C