DATA LIST
Using the GTS to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any parts. This non-intrusive inspection can be very useful because intermittent conditions or signals may be discovered before parts or wiring is disturbed. Reading the Data List information early in troubleshooting is one way to save diagnostic time.
In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a part is faulty or not.
According to the display on the GTS, read the Data List.
| Tester Display | Measurement Item | Range | Normal Condition | Diagnostic Note |
|---|---|---|---|---|
| HV/EV/ENG Data Check | Verification of the HV/EV/ENG data | OK/NG | OK: Data verification normal
NG: Data verification abnormal |
- |
| 2WD/4WD Data Check | Verification of the 2WD/4WD data | OK/NG | OK: Data verification normal
NG: Data verification abnormal |
- |
| Image Processing IC Written Protect Record | A history item indicating that the image processing IC memory was write protected | Unrec/Rec | Unrec: Parking assist ECU normal
Rec: Parking assist ECU abnormal |
- |
| Image Processing IC Initialized Malfunction Record | A history item indicating that the image processing IC memory was not initialized | Unrec/Rec | Unrec: Parking assist ECU normal
Rec: Parking assist ECU abnormal |
- |
| Main EEPROM Access Status | Main EEPROM access status | OK/NG | OK: Parking assist ECU normal
NG: Parking assist ECU abnormal |
- |
| System Power Supply Voltage Malfunction Record | A history item indicating an abnormally generated voltage value from the system power source | Unrec/Rec | Unrec: Parking assist ECU normal
Rec: Parking assist ECU abnormal |
- |
| Main CPU Starting Malfunction Record | A history item indicating that the main CPU did not start | Unrec/Rec | Unrec: Parking assist ECU normal
Rec: Parking assist ECU abnormal |
- |
| Wheel Speed Sensor (4wheel) | Reception state of the vehicle speed signal from the skid control ECU | OK/NG | OK: Speed signal received
NG: Speed signal not received |
- |
| Continuous Bus Off | Continuous bus off status (Global) | Not Detected/Detected | Not Detected: Communication condition available
Detected: Communication condition not available |
- |
| Sending CAN Message | Communication condition from parking assist ECU (Global) | OK/NG | OK: Communication condition available
NG: Communication condition not available |
- |
| Camera Changing SW Signal Status | Signal status at the BLSW terminal (switch camera signal) | ON/OFF | ON: Panoramic view monitor switch on
OFF: Panoramic view monitor switch off |
- |
| Image Adjustment Status | Status of the image adjustment status | Incomplete/Processing/Complete | Incomplete: Image adjustment incomplete
Processing: Image adjustment in processing Complete: Image adjustment completed |
- |
| Number of DTC | Number of DTCs (past and present) | Min: 0, Max: 255 | Changes according to the number of DTCs output | - |