Home › Audio / Visual / Telematics › PARK ASSIST / MONITORING › PANORAMIC VIEW MONITOR SYSTEM (w/o Advanced Park) › from 2021.07
RM3700E _56 Audio / Visual / Telematics _093031 PARK ASSIST / MONITORING _0485737 PANORAMIC VIEW MONITOR SYSTEM(w/o Advanced Park) C

PARK ASSIST / MONITORING  PANORAMIC VIEW MONITOR SYSTEM(w/o Advanced Park)  C168D  Vehicle Information Unmatched  


DESCRIPTION

This DTC is stored if the parking assist ECU judges as a result of its self check that the vehicle information received via CAN communication and the vehicle information stored in the parking assist ECU do not match.

DTC No. Detection Item DTC Detection Condition Trouble Area DTC Output from Priority
C168D Vehicle Information Unmatched Vehicle information unmatched
·

Camera view adjustment (calibration)

·

Steering angle setting

·

Parking assist ECU


Circumference Monitoring Camera Control Module A

CAUTION / NOTICE / HINT

NOTICE:
·

When "!" mark is displayed on the parking assist ECU after the cable is disconnected from the negative (-) auxiliary battery terminal, correct the steering angle neutral point.

Click hereAudio / Visual / Telematics>PARK ASSIST / MONITORING>PANORAMIC VIEW MONITOR SYSTEM (w/o Advanced Park)>INITIALIZATION

·

Depending on the parts that are replaced or operations that are performed during vehicle inspection or maintenance, calibration of other systems as well as the panoramic view monitor system may be needed.

Click hereAudio / Visual / Telematics>PARK ASSIST / MONITORING>PANORAMIC VIEW MONITOR SYSTEM (w/o Advanced Park)>CALIBRATION



PROCEDURE

1.PERFORM SETTINGS (CAMERA VIEW ADJUSTMENT [CALIBRATION], STEERING ANGLE SETTING)
a.

Perform the following procedure depending on the memory conditions to register the vehicle information to the parking assist ECU.




Result:
Proceed to
NEXT



NEXT

2.CLEAR DTC
2.CLEAR DTC
a.

Clear the DTCs.

HINT:

Click hereAudio / Visual / Telematics>PARK ASSIST / MONITORING>PANORAMIC VIEW MONITOR SYSTEM (w/o Advanced Park)>DTC CHECK / CLEAR


Chassis > Circumference Monitoring Camera Control Module > Clear DTCs
50002 353
Result:
Proceed to
NEXT




NEXT

3.CHECK FOR DTC
3.CHECK FOR DTC
a.

Check for DTCs.

HINT:

Click hereAudio / Visual / Telematics>PARK ASSIST / MONITORING>PANORAMIC VIEW MONITOR SYSTEM (w/o Advanced Park)>DTC CHECK / CLEAR


Chassis > Circumference Monitoring Camera Control Module > Trouble Codes
50001 353
HINT:
·

If DTC C168D is output, perform the procedure to allow the parking assist ECU to store the vehicle information again.

·

If DTC C168D is still output after performing the procedure to make the parking assist ECU store the vehicle information 3 times, replace the parking assist ECU.



Result:
Result Proceed to
DTCs are not output A
C168D is output B




A

END (SETTINGS ARE DEFECTIVE)

B

4.READ VALUE USING GTS
4.READ VALUE USING GTS
a.

Read the Data List according to the display on the GTS.

Chassis > Circumference Monitoring Camera Control Module > Data List
Tester Display Measurement Item Range Normal Condition Diagnostic Note
Back Camera Availability Consistency Status of ECU stored in rear television camera assembly OK/NG OK: Normal
NG: Rear television camera assembly or parking assist ECU abnormal
-
Chassis > Circumference Monitoring Camera Control Module > Data List
Tester Display
Back Camera Availability Consistency
50003 353 53
Result:
Result Proceed to
"NG" is displayed. A
"OK" is displayed. B




A

B