PARKING ASSIST ECU
Disconnect the O118 parking assist ECU connector.
Measure the voltage and resistance according to the value(s) in the table below.
| Terminal No. (Symbol) | Terminal Description | Condition | Specified Condition |
|---|---|---|---|
| O118-1 (+B) - O118-4 (GND1) | Power source signal | Ignition switch off | 11 to 14 V |
| O118-2 (ACC) - O118-4 (GND1) | ACC power source signal | Ignition switch ACC | 11 to 14 V |
| Ignition switch off | Below 1 V | ||
| O118-3 (IG) - O118-4 (GND1) | IG power source signal | Ignition switch ON | 11 to 14 V |
| Ignition switch off | Below 1 V | ||
| O118-4 (GND1) - Body ground | Ground | Always | Below 1 Ω |
Reconnect the O118 parking assist ECU connector.
Measure the voltage, resistance and waveform according to the value(s) in the table below.
| Terminal No. (Symbol) | Terminal Description | Condition | Specified Condition |
|---|---|---|---|
| O118-9 (CANH) | CAN communication line | - | - |
| O118-10 (CANL) | CAN communication line | - | - |
| O118-5 (RSW+) - O118-4 (GND1) | Terminal required by law | Panoramic image being displayed | 0 to 2 V |
| Panoramic image not being displayed | 5.5 to 7.05 V | ||
| O118-8 (IRSW) - Body ground | Parking assist light signal | Ignition switch ON, parking assist light on | 11 to 14 V |
| Ignition switch ON, parking assist light off | Below 1 V | ||
| O118-14 (REV) - Body ground | Reverse signal | Ignition switch ON, shift lever in R | 11 to 14 V |
| Ignition switch ON, shift lever not in R | Below 1 V | ||
| O118-15 (BLSW) - O118-4 (GND1) | Panoramic view monitor switch signal | Ignition switch ON, panoramic view monitor switch off | 5.5 to 6.5 V |
| Ignition switch ON, panoramic view monitor switch on | Below 1 V | ||
| O118-12 (NS+) - O118-11 (NS-) | Video signal | Ignition switch ON, panoramic view monitor switch on, camera lens not covered, displaying image | Pulse generation (See waveform 1) |
| O118-11 (NS-) - Body ground | Video signal | Always | Below 1 Ω |
| O118-13 (NSG) - Body ground | Shield ground | Always | Below 1 Ω |
| O120-1 (BGND) - Body ground | Front television camera assembly display ground | Always | Below 1 Ω |
| O120-2 (BCB+) - O120-1 (BGND) | Power source to front television camera | Ignition switch ON | 7 to 8 V |
| O120-3 (BCV-) | Front television camera assembly display ground | - | - |
| O120-4 (BCV+) | Front television camera assembly display signal input | - | - |
| O120-5 (SGND) - Body ground | Front television camera assembly ground (shield) | Always | Below 1 Ω |
| O122-1 (LGND) - Body ground | Side television camera assembly LH ground | Always | Below 1 Ω |
| O122-2 (LCB+) - O122-1 (LGND) | Power source to side television camera assembly LH | Ignition switch ON | 7 to 8 V |
| O122-3 (LCV-) | Side television camera assembly LH display ground | - | - |
| O122-4 (LCV+) | Side television camera assembly LH display signal input | - | - |
| O122-5 (SGND) - Body ground | Side television camera assembly LH ground (shield) | Always | Below 1 Ω |
| O123-1 (CGND) - Body ground | Rear television camera assembly ground | Always | Below 1 Ω |
| O123-2 (CB+) - O123-1 (CGND) | Power source to rear television camera assembly | Ignition switch ON | 7 to 8 V |
| O123-3 (CV-) | Rear television camera assembly display ground | - | - |
| O123-4 (CV+) | Rear television camera assembly display signal input | - | - |
| O123-5 (SGND) - Body ground | Rear television camera assembly ground (shield) | Always | Below 1 Ω |
| O121-1 (RGND) - Body ground | Side television camera assembly RH display ground | Always | Below 1 Ω |
| O121-2 (RCB+) - O121-1 (RGND) | Power source to side television camera assembly RH | Ignition switch ON | 7 to 8 V |
| O121-3 (RCV-) | Side television camera assembly RH display ground | - | - |
| O121-4 (RCV+) | Side television camera assembly RH display signal input | - | - |
| O121-5 (SGND) - Body ground | Side television camera assembly RH ground (shield) | Always | Below 1 Ω |
Using an oscilloscope, check the waveform.
| *a | Waveform 1 (camera lens is not covered, displaying an image) |
| *b | Synchronization Signal |
| *c | Video Waveform |
Waveform 1
| Item | Content |
|---|---|
| Measurement terminal | O118-12 (NS+) - O118-11 (NS-) |
| Measurement setting | 200 mV/DIV., 50 μs./DIV. |
| Condition | Ignition switch ON, panoramic view monitor switch on, camera lens not covered, displaying image |
The video waveform changes according to the image sent by the parking assist ECU.
RADIO AND DISPLAY RECEIVER ASSEMBLY
w/ NAVIGATION SYSTEM:
Click hereAudio / Visual / Telematics>NAVIGATION / MULTI INFO DISPLAY>NAVIGATION SYSTEM>TERMINALS OF ECU
w/ AUDIO AND VISUAL SYSTEM (for Radio and Display Type without TAS Type):