89611
1.INSPECT POWER SWITCH
Check the resistance.
| *a | Component without harness connected
(Power Switch) |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
|
Click Location & Routing(H69)Location & Routingewd_type=routing;type=c;code=H69 Click Connector(H69)Instrument Panel>Instrument Panel Wire / Speaker Wire>Power Switchewd_type=component;type=c;code=H69;pinno=12,3,6,11 |
||
| H69-12(SS1) - H69-3(GND) | Not pushed | 10 kΩ or higher |
| H69-12(SS1) - H69-3(GND) | Pushed | Below 1 Ω |
| H69-6(SS2) - H69-3(GND) | Not pushed | 10 kΩ or higher |
| H69-6(SS2) - H69-3(GND) | Pushed | Below 1 Ω |
| H69-11(SS3) - H69-3(GND) | Not pushed | 10 kΩ or higher |
| H69-11(SS3) - H69-3(GND) | Pushed | Below 1 Ω |
If the result is not as specified, replace the power switch.
Check the LED illumination.
| *a | Component without harness connected
(Power Switch) |
Apply battery voltage between the terminals of the power switch and check the illumination condition of the power switch indicator light.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
|
Click Location & Routing(H69)Location & Routingewd_type=routing;type=c;code=H69 Click Connector(H69)Instrument Panel>Instrument Panel Wire / Speaker Wire>Power Switchewd_type=component;type=c;code=H69;pinno=5,3 |
||
| H69-5(SWIL) - H69-3(GND) | H69-5(SWIL) - Auxiliary battery positive (+)
H69-3(GND) - Auxiliary battery negative (-) |
Illuminates |
If the positive (+) lead and the negative (-) lead are incorrectly connected, the power switch indicator light will not illuminate.
If the voltage is too low, the power switch indicator light will not illuminate.
If the result is not as specified, replace the power switch.