Home › Audio / Visual / Telematics › TELEMATICS › TELEMATICS SYSTEM (for Toyota Connected Services) › from 2021.07
RM3700E _56 Audio / Visual / Telematics _093836 TELEMATICS _0444943 TELEMATICS SYSTEM(for Toyota Connected Services) C

TELEMATICS  TELEMATICS SYSTEM(for Toyota Connected Services)  B157213  Microphone Circuit Open  


DESCRIPTION

This DTC is stored when a telephone microphone assembly signal line is disconnected.

DTC No. Detection Item DTC Detection Condition Trouble Area DTC Output from Priority
B157213 Microphone Circuit Open Current at terminal MCVD exceeds the malfunction threshold for 10 seconds or more while the ignition switch is ON
·

Telematics transceiver

·

Telephone microphone assembly

·

Harness or connector

·

Map light assembly


Telematics A

WIRING DIAGRAM

E384839E32
0.729,0.854 1.26,1.063 0.531,0.208 10 false MACC 0.813,1.323 1.271,1.531 0.458,0.208 10 false MIC+ 0.823,1.802 1.281,2.01 0.458,0.208 10 false MIC- 0.292,2.417 1.698,2.792 1.406,0.375 10 false Telephone Microphone Assembly 1.313,0.76 1.469,0.958 0.156,0.198 10 false 4 1.313,1.24 1.469,1.438 0.156,0.198 10 false 3 1.313,1.708 1.469,1.906 0.156,0.198 10 false 2 2.063,0.75 2.365,0.99 0.302,0.24 10 false 16 2.073,1.219 2.313,1.448 0.24,0.229 10 false 15 2.073,1.708 2.365,1.927 0.292,0.219 10 false 14 1.521,0.76 2.052,0.969 0.531,0.208 10 false MACC 1.531,1.25 2.063,1.458 0.531,0.208 10 false MCO+ 1.542,1.719 2.073,1.927 0.531,0.208 10 false MCO- 0.396,3.167 0.896,3.438 0.5,0.271 10 false V7 0.406,3.313 1.75,3.583 1.344,0.271 10 false Map Light Assembly 5.646,0.76 5.885,0.958 0.24,0.198 10 false 5 5.646,1.24 5.885,1.438 0.24,0.198 10 false 6 5.656,1.719 5.896,1.917 0.24,0.198 10 false 7 5.615,2.292 5.854,2.49 0.24,0.198 10 false 23 5.938,0.833 6.469,1.042 0.531,0.208 10 false MCVD 5.917,1.323 6.448,1.531 0.531,0.208 10 false MCI+ 5.927,2.385 6.458,2.594 0.531,0.208 10 false SGND 5.917,1.792 6.448,2 0.531,0.208 10 false MCI- 5.563,2.76 6.25,3.073 0.688,0.313 10 false H85 5.563,2.927 7.042,3.177 1.479,0.25 10 false Telematics Transceiver 3.781,2.323 3.938,2.49 0.156,0.167 10 false * 2.49,3.344 3.552,3.573 1.063,0.229 10 false *: Shielded 0.292,2.229 0.458,2.458 0.167,0.229 10 false B

CAUTION / NOTICE / HINT

NOTICE:

Depending on the parts that are replaced during vehicle inspection or maintenance, performing initialization, registration or calibration may be needed. Refer to Registration for Telematics System (for eCall).

Click hereAudio / Visual / Telematics>TELEMATICS>TELEMATICS SYSTEM (for Toyota Connected Services)>REGISTRATION


PROCEDURE

1.CLEAR DTC
a.

Clear the DTCs.

Body Electrical > Telematics > Clear DTCs
50002 459

Result:
Proceed to
NEXT



NEXT

2.CHECK DTC
2.CHECK DTC
a.

Turn the ignition switch to ON and wait for 10 seconds or more.


b.

Check for DTCs and check that no DTCs are output.

Body Electrical > Telematics > Trouble Codes
50001 459

Result:
Result Proceed to
DTCs are not output A
B153711 or B153713 is output B
None of the above conditions are met C



A

B

3.CHECK HARNESS AND CONNECTOR (TELEMATICS TRANSCEIVER - MAP LIGHT ASSEMBLY (TELEPHONE MICROPHONE ASSEMBLY))

C

3.CHECK HARNESS AND CONNECTOR (TELEMATICS TRANSCEIVER - MAP LIGHT ASSEMBLY (TELEPHONE MICROPHONE ASSEMBLY))

Pre-procedure1

a.

Disconnect the H85 telematics transceiver connector.


b.

Disconnect the V7 map light assembly (telephone microphone assembly) connector.


Procedure1

a.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition

Click Location & Routing(H85,V7)Location & Routing

Click Connector(H85)Instrument Panel>Instrument Panel Wire / Speaker Wire>Telematics Transceiver

Click Connector(V7)Body>No. 1 Roof Wire>Map Light Assembly

H85-5 (MCVD) - V7-16 (MACC) Always Below 1 Ω
H85-6 (MCI+) - V7-15 (MCO+) Always Below 1 Ω
H85-7 (MCI-) - V7-14 (MCO-) Always Below 1 Ω
H85-5 (MCVD) or V7-16 (MACC) - Body ground Always 10 kΩ or higher
H85-6 (MCI+) or V7-15 (MCO+) - Body ground Always 10 kΩ or higher
H85-7 (MCI-) or V7-14 (MCO-) - Body ground Always 10 kΩ or higher
H85-23 (SGND) - Body ground Always 10 kΩ or higher


Result:
Proceed to
OK
NG



Post-procedure1

a.

None



OK

4.CHECK TELEMATICS TRANSCEIVER

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR

4.CHECK TELEMATICS TRANSCEIVER
a.
E442560C09
1.385,0.573 1.958,0.885 0.573,0.313 2.49,1.813 2.948,0.979 true 0.25,0.302 0.563,0.5 0.313,0.198 10 false *a 1.531,0.646 2.073,0.865 0.542,0.219 10 false H85 3,0.875 3.427,1.125 0.427,0.25 10 false MCVD
*a Component with harness connected
(Telematics Transceiver)


Measure the voltage and resistance according to the value(s) in the table below.

Standard Voltage:
Tester Connection Switch Condition Specified Condition

Click Location & Routing(H85)Location & Routing

Click Connector(H85)Instrument Panel>Instrument Panel Wire / Speaker Wire>Telematics Transceiver

H85-5 (MCVD) - Body ground Ignition switch ON 4 to 6 V



Result:
Proceed to
OK
NG



OK

5.INSPECT MAP LIGHT ASSEMBLY

NG

10.REPLACE TELEMATICS TRANSCEIVER
5.INSPECT MAP LIGHT ASSEMBLY

Pre-procedure1

a.

Remove the map light assembly.

HINT:

Click hereVehicle Interior>LIGHTING (INT)>PERSONAL LIGHT>REMOVAL



b.

Remove the telephone microphone assembly.

HINT:

Click hereAudio / Visual / Telematics>TELEMATICS>TELEMATICS TRANSCEIVER (except TAS Type)>REMOVAL



Procedure1

a.
E434436C02
1.5,0.25 2,0.5 0.5,0.25 1.458,1.917 1.958,2.167 0.5,0.25 1.042,3.104 1.406,2.625 true 1.417,3.25 1.688,2.635 true 2.417,3.083 2.031,2.615 true 0.844,1.198 0.542,1.594 true 0.979,1.615 0.979,1.229 true 1.094,1.229 1.25,1.521 true 1.667,0.292 1.979,0.49 0.313,0.198 10 false V7 1.646,1.958 1.958,2.156 0.313,0.198 10 false B 2.458,3.073 3.073,3.271 0.615,0.198 10 false MACC 1.104,3.229 1.719,3.427 0.615,0.198 10 false MIC+ 0.75,3.042 1.365,3.24 0.615,0.198 10 false MIC 0.083,1.51 0.573,1.698 0.49,0.188 10 false MACC 0.802,1.646 1.417,1.844 0.615,0.198 10 false MCO+ 1.313,1.479 1.927,1.677 0.615,0.198 10 false MCO- 0.219,0.167 0.708,0.354 0.49,0.188 10 false *a
*a Component without harness connected
(Map Light Assembly)


Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition

Click Location & Routing(V7)Location & Routing

Click Connector(V7)Body>No. 1 Roof Wire>Map Light Assembly

V7-16 (MACC) - B-14 (MACC) Always Below 1 Ω
V7-15 (MCO+) - B-15 (MIC+) Always Below 1 Ω
V7-14 (MCO-) - B-16 (MIC-) Always Below 1 Ω
V7-16 (MACC) - V7-15 (MCO+) Always 10 kΩ or higher
V7-16 (MACC) - V7-14 (MCO-) Always 10 kΩ or higher
V7-15 (MCO+) - V7-14 (MCO-) Always 10 kΩ or higher


Result:
Proceed to
OK
NG



Post-procedure1

a.

None



OK

6.REPLACE TELEPHONE MICROPHONE ASSEMBLY

NG

REPLACE MAP LIGHT ASSEMBLY

6.REPLACE TELEPHONE MICROPHONE ASSEMBLY
a.

Replace the telephone microphone assembly with a new or known good one.

HINT:

Click hereAudio / Visual / Telematics>TELEMATICS>TELEMATICS TRANSCEIVER (except TAS Type)>REMOVAL



Result:
Proceed to
NEXT



NEXT

7.CLEAR DTC
7.CLEAR DTC
a.

Clear the DTCs.

Body Electrical > Telematics > Clear DTCs
50002 459

Result:
Proceed to
NEXT



NEXT

8.CHECK DTC
8.CHECK DTC
a.

Turn the ignition switch to ON and wait for 10 seconds or more.


b.

Check for DTCs and check that no DTCs are output.

Body Electrical > Telematics > Trouble Codes
50001 459

Result:
Result Proceed to
DTCs are not output A
B157213 is output B
None of the above conditions are met C



A

END (TELEPHONE MICROPHONE ASSEMBLY IS DEFECTIVE)

B

9.REPLACE TELEMATICS TRANSCEIVER

C

9.REPLACE TELEMATICS TRANSCEIVER
a.

Replace the telematics transceiver with a new one.

HINT:

Click hereAudio / Visual / Telematics>TELEMATICS>TELEMATICS TRANSCEIVER (except TAS Type)>REMOVAL



Result:
Proceed to
NEXT



NEXT

10.REPLACE TELEMATICS TRANSCEIVER
a.

Replace the telematics transceiver with a new one.

HINT:

Click hereAudio / Visual / Telematics>TELEMATICS>TELEMATICS TRANSCEIVER (except TAS Type)>REMOVAL



Result:
Proceed to
NEXT



NEXT