WORK NOTICES AND PRECAUTIONS (for Sedan) > PRECAUTIONS FOR WELDING



REMOVAL OF ADJACENT COMPONENTS


    K100267
  1. To prevent damage to the body and parts, apply protective tape to the body and tools before removing the parts.

    NOTICE:
    If the paint film is damaged, make sure to refinish the paint.


ANTI-RUST TREATMENT BEFORE WELDING


    K100268
  1. Apply welding primer to the contact surfaces of the welding areas to protect them from rust.

    NOTICE:
    Do not apply welding primer outside of the contact surfaces.


WELDING PRECAUTIONS
K100274E01
Text in Illustration 
*1
Old Spot Locations
*2
New Spot Locations
  1. The number of welding spots should be as follows.
    Number of spot welds:
    More than 1.3x the number of welds made by the manufacturer
    Number of plug welds:
    More than the number of welds made by the manufacturer

  2. Spot weld locations
    Avoid welding over previously welded areas.


MAKING HOLES FOR PLUG WELDING
K100275E01
Text in Illustration 
*1
Puncher
  1. For areas where a spot welder cannot be used, use a puncher or drill to make holes for plug welding.
    Thickness of welded portion
    Diameter of plug hole
    Under 1.0 mm (0.04 in.)
    Over 5.0 mm (0.20 in.)
    1.0 to 1.6 mm (0.04 to 0.06 in.)
    Over 6.5 mm (0.26 in.)
    1.7 to 2.3 mm (0.07 to 0.09 in.)
    Over 8.0 mm (0.31 in.)
    Over 2.4 mm (0.09 in.)
    Over 10 mm (0.39 in.)