WHEN REMOVING,INSTALLING,REPAIRING OR REPLACING PARTS (for Sedan) > REPAIR PROCEDURE OF HEADLIGHT ASSEMBLY



INSTALL HEADLIGHT PROTECTOR RETAINER UPPER


  1. HINT:
    1. If only the installation area of the headlight is damaged, use a bracket for a low-cost repair.
    2. Ensure that other areas of the headlight are not damaged.




      E129685
    1. Cut off the portion indicated by the hatched lines in the illustration and smooth the surface with sandpaper.

      NOTICE:
      After cutting off the shaded portion, place the headlight protector retainer upper against the bosses and gradually file away the shaded portion until installation is possible.



    2. E129686
    3. Install the headlight protector retainer upper with the 2 screws.


INSTALL HEADLIGHT PROTECTOR RETAINER LOWER


  1. HINT:
    1. If only the installation area of the headlight is damaged, use a bracket for a low-cost repair.
    2. Ensure that other areas of the headlight are not damaged.




      E129687
    1. Cut off the portion indicated by the hatched lines in the illustration and smooth the surface with sandpaper

      NOTICE:
      After cutting off the shaded portion, place the headlight protector retainer lower against the bosses and gradually file away the shaded portion until installation is possible.



    2. E129688
    3. Install the headlight protector retainer lower with the 2 screws.