WHEN REMOVING,INSTALLING,REPAIRING OR REPLACING PARTS (for Sedan) > PROCEDURES NECESSARY WHEN ECU OR OTHER PARTS ARE REPLACED



PROCEDURES NECESSARY WHEN ECU OR OTHER PARTS ARE REPLACED

Procedures Necessary when ECU or Other Parts are Replaced 
Replacement Part
Necessary Procedures
Effect / Inoperative Function when Necessary Procedures are not Performed
ECM
Register VIN.
DTC P0630 is output
Registration
Engine starting
  1. ECM or Throttle body assembly
  2. Throttle body is cleaned
Initialization
-
Automatic transaxle assembly, engine assembly or ECM
  1. Road test
  2. Reset memory
Large shift shock
Tire pressure warning ECU
Register transmitter IDs
  1. When DTC detection conditions of "transmitter ID not received" DTC is met, tire pressure warning light blinks for 1 minute, and then illuminates
  2. Tire pressure monitoring function
Tire pressure warning valve and transmitter
Yaw rate and acceleration sensor
  1. Clearing zero point calibration data
  2. Yaw rate and acceleration sensor zero point calibration
  1. VSC control is prohibited or operation is incorrect
Skid control ECU (Brake actuator assembly)
Yaw rate and acceleration sensor zero point calibration
  1. VSC control is prohibited or operation is incorrect
Front wheel alignment
  1. Clearing zero point calibration data
  2. Yaw rate and acceleration sensor zero point calibration
  1. VSC control is prohibited or operation is incorrect
  1. Power steering ECU
  2. Power steering column assembly
  3. Steering wheel
  4. Steering gear assembly
Perform rotation angle sensor initialization and torque sensor zero point calibration
  1. Power steering warning light comes on
  2. EPS control
Door control receiver assembly
Registration
Wireless door lock control system
Key
Transponder key ECU
Registration
Engine starting
Key
  1. Occupant classification ECU
  2. Accessories (seatback tray and seat cover, etc.) are installed
  3. Front passenger seat is removed from the vehicle
  4. Vehicle is brought to the workshop for repair due to an accident or a collision
  1. Perform zero point calibration
  2. Sensitivity check
  1. Occupant classification system
  2. Airbag system (Front passenger side)
  3. Seat belt warning system (Front passenger side)