WHEN REMOVING,INSTALLING,REPAIRING OR REPLACING PARTS (for Hatchback) > PROCEDURES NECESSARY WHEN ECU OR OTHER PARTS ARE REPLACED



PROCEDURES NECESSARY WHEN ECU OR OTHER PARTS ARE REPLACED
*1: w/ Wireless Door Lock Control System
*2: w/o Wireless Door Lock Control System
*3: w/ Tire Pressure Warning System
*4: w/o Tire Pressure Warning System

Procedures Necessary when ECU or Other Parts are Replaced 
Replacement Part
Necessary Procedure
Effect or Inoperative Function when Necessary Procedure is not Performed
ECM
Vehicle Identification Number (VIN) registration
DTC P0630 is output
ECU communication ID registration
(Engine immobiliser system)
Engine starting
  1. Throttle with motor body assembly
  2. Engine assembly
  3. Cylinder head
  4. Camshaft (for intake or exhaust side)
  5. Camshaft timing gear assembly (for intake or exhaust side)
  6. Piston or piston ring
  7. Mass air flow meter
  8. Fuel injector assembly
  9. Fuel pump
  10. Air fuel ratio sensor
  11. Engine coolant temperature sensor
  12. Spark plug
  13. Ignition coil assembly
  14. EGR valve assembly
  15. Knock sensor
Inspection after repairs
-
Automatic transaxle assembly, engine assembly or ECM
  1. Road test
  2. Reset memory
Large shift shock
  1. Door control and tire pressure monitoring system receiver assembly*1
  2. Tire pressure monitor receiver assembly*2
Register transmitter IDs
  1. When DTC detection conditions of "transmitter ID not received" DTC is met, tire pressure warning light blinks for 1 minute, and then illuminates
  2. Tire pressure monitoring function
Tire pressure warning valve and transmitter
Yaw rate sensor (Air bag sensor assembly)
  1. Clearing zero point calibration data
  2. Yaw rate and acceleration sensor zero point calibration
VSC control is prohibited or operation is incorrect
Skid control ECU
(Brake actuator assembly)
Yaw rate and acceleration sensor zero point calibration
VSC control is prohibited or operation is incorrect
Front wheel alignment
  1. Clearing zero point calibration data
  2. Yaw rate and acceleration sensor zero point calibration
VSC control is prohibited or operation is incorrect
  1. Power steering ECU
  2. Power steering column sub-assembly
  3. Power steering motor
  4. Steering wheel
  5. Steering gear assembly
Perform rotation angle sensor initialization and torque sensor zero point calibration
  1. Power steering warning light comes on
  2. EPS control
  1. Door control and tire pressure monitoring system receiver assembly*3
  2. Door control receiver*4
  3. Key
Code registration
Wireless door lock system
  1. Transponder key ECU
  2. Key
  3. ECM
ECU communication ID registration
(Engine immobiliser system)
Engine start
  1. Occupant classification ECU
  2. Accessories (seatback tray and seat cover, etc.) are installed
  3. Front passenger seat is removed from the vehicle
  4. Vehicle is brought to the workshop for repair due to an accident or a collision
  1. Perform zero point calibration
  2. Sensitivity check
  1. Occupant classification system
  2. Airbag system (Front passenger side)
  3. Seat belt warning system (Front passenger side)