FRONT SIDE MEMBER (for Hatchback) > CUT AND JOIN REPLACEMENT SECTIONS (SMALL AREAS)



  1. K100643
    With the radiator side support removed.

REMOVAL

Symbol meaning
K100014
Remove Weld Points
K100016
Remove Weld Points
K100023
Cut and Join Location
REMOVAL POINT
  1. After removing the *1, remove the front side member reinforcement.
  2. Carefully cut the front side member reinforcement so not to damage *2.

Reference Value 
Area
Measurement
Area
Measurement
*a
30 mm (1.18 in.)
*b
310 mm (12.20 in.)
*c
47 mm (1.85 in.)
*d
232 mm (9.13 in.)
*e
310 mm (12.20 in.)
-
-

K101490E02


K101859E01


K101492E01


INSTALLATION

Symbol meaning
K100014
Remove Weld Points
K100019
Plug Weld
K100021
Plug Weld
K100023
Cut and Join Location
K100027
Butt Weld
INSTALLATION POINT
  1. Temporarily install the new parts and measure each part of the new parts in accordance with the body dimension diagram. (See the body dimensions)
  2. If the entire supply part is not needed, remove the part of the supply part that is needed.
  3. *1 is reused.
  4. After welding the *2 to the vehicle side, install the *1.
  5. After applying the top coat, apply anti-rust agent to the internal panel portion of the closed section structural weld points.

K101493E01


K101494E01