REAR FLOOR PAN (for Hatchback) > ASSEMBLY REPLACEMENT



  1. K100574
    With the floor side rail front panel removed.

REMOVAL

Symbol meaning
K100014
Remove Weld Points
REMOVAL POINT
  1. After removing the rear floor brace bracket, remove the rear floor pan.

K101714E01


INSTALLATION

Symbol meaning
K100019
Plug Weld
K100026
Fillet Weld
INSTALLATION POINT
  1. Before temporarily installing the new parts, weld the rear floor pan, spare wheel clamp bracket, fuel tube bracket, fuel tube bracket No.2 and weld bolts with the standard number of welding points.
  2. After welding the rear floor pan to the vehicle side, install the rear floor brace bracket.
  3. After welding, apply body sealer and undercoating to the corresponding parts. (See the painting / coating)
  4. After applying the top coat, apply anti-rust agent to the internal panel portion of the closed section structural weld points.

K101715E01


K101716E01