NAME PLATE (for Sedan) > ATTACHMENT POSITION


  1. Heat the double-sided tape remaining on the body with an infrared lamp or equivalent.

    HINT:
    Heat the tape to 40 to 60°C for approximately 1 to 2 minutes.

  2. Wipe off the remaining double-sided tape using a clean cloth or equivalent.

    NOTICE:
    If a name plate is installed without thoroughly removing the remaining double-sided tape from the body, the name plate will not adhere properly. Make sure to thoroughly wipe off the double-sided tape.

  3. After cleaning the installation area of the body with degreasing agent, attach the name plate to the position shown in the illustration.

    HINT:
    The working environment should be 20°C when installing the name plate. If the working environment is below 20°C, heat the installation area of the body to 20 to 30°C and then install the name plate.


Text in Illustration 
*1
NO. 6 LUGGAGE COMPARTMENT DOOR NAME PLATE
*2
NO. 2 LUGGAGE COMPARTMENT DOOR NAME PLATE
*3
Outside Line of Luggage Compartment Door Panel
-
-

Reference Value 
Area
Measurement
Area
Measurement
*a
52.8 mm (2.079 in.)
*b
17.1 mm (0.673 in.)
*c
162.3 mm (0.390 in.)
*d
20 mm (0.787 in.)
*e
39.4 mm (1.551 in.)
*f
44.7 mm (1.760 in.)
*g
162.4 mm (6.394 in.)
*h
17.8 mm (0.701 in.)

K102092E01