FRONT SIDE MEMBER (for Sedan) > ASSEMBLY REPLACEMENT (PATTERN 1)



  1. K101652
    With the radiator side support removed.

REMOVAL

Symbol meaning
K100014
Remove Weld Points
K100015
Remove Weld Points
K100016
Remove Weld Points

K101795E01


K101796E01


INSTALLATION

Symbol meaning
K100019
Plug Weld
K100020
Plug Weld
K100021
Plug Weld
INSTALLATION POINT
  1. Temporarily install the new parts and measure each part of the new parts in accordance with the body dimension diagram. (See the body dimensions)
  2. When welding *1, make a hole on a new part for plug welding and weld the panel with the panel behind completely.
  3. Make sure to attach correctly in accordance with the body dimension diagram as this part affects the front wheel alignment.
  4. After welding, apply body sealer and undercoating to the corresponding parts. (See the painting / coating)
  5. After applying the top coat, apply anti-rust agent to the internal panel portion of the closed section structural weld points.

K101797E01


K101798E01