QUARTER WHEEL HOUSING OUTER PANEL (for Sedan) > ASSEMBLY REPLACEMENT
With the quarter panel removed.
REMOVAL
Symbol meaning
Remove Weld Points
Remove Weld Points
Remove Weld Points
REMOVAL POINT
*1 is reused.
After removing the *1 and roof side panel outer, remove the quarter wheel house panel outer.
INSTALLATION
Symbol meaning
Spot Weld
Plug Weld
Plug Weld
Plug Weld
Body Sealer
Assembly Mark
INSTALLATION POINT
When welding *1, make a hole on a new part for plug welding and weld the panel with the panel behind completely.
For positioning of the new parts, align the installation standard holes of the outer panel and the inner panel.
Before installing a new part, apply body sealer.
HINT:
Apply body sealer in an even, continuous bead.
After welding the quarter wheel house panel outer to the vehicle side, install the roof side panel outer and *2.
After welding, apply body sealer and undercoating to the corresponding parts. (See the painting / coating)
After applying the top coat, apply anti-rust agent to the internal panel portion of the closed section structural weld points.