REAR FLOOR PAN (for Sedan) > ASSEMBLY REPLACEMENT



  1. K101691
    With the floor side rail front panel removed.

REMOVAL

Symbol meaning
K100014
Remove Weld Points

K101712E01


INSTALLATION

Symbol meaning
K100019
Plug Weld
K100026
Fillet Weld
INSTALLATION POINT
  1. Before temporarily installing the new parts, weld the rear floor pan, spare wheel clamp bracket, fuel tube bracket, fuel tube bracket No.2, actuator cover bracket No.3 and weld bolts with the standard number of welding points.
  2. After welding, apply body sealer and undercoating to the corresponding parts. (See the painting / coating)
  3. After applying the top coat, apply anti-rust agent to the internal panel portion of the closed section structural weld points.

K101713E01


K101712E02