ENGINE COMPARTMENT (for Sedan) > THREE-DIMENSIONAL DISTANCE


HINT:
  1. In cases in which only one dimension is given, left and right are symmetrical.
  1. For symbols, capital letters indicate right side of vehicle, small letters indicate left side of vehicle (seen from rear).


Measuring Point Name 
Symbol
Name
Hole Diameter
mm (in.)
A, a
Front Fender Installation Nut
M6 (0.24)
B, b
Front Spring Support Standard Hole
φ11 (0.43)
C, c
Hood Hinge Installation Nut
M8 (0.31)
D
Cowl Top Inner Panel Center Mark
-
E, e
Front Side Member Standard Hole
φ15 (0.59)
F, f
Front Side Member Standard Hole
φ10 (0.39)
G, g
Headlight Installation Hole
9X9 (0.35X0.35)
H, h
Front Bumper Reinforcement Installation Hole
φ6.3 (0.25)
J, j
Radiator Seal Installation Hole
φ9 (0.35)
K, k
Front Fender Extension Standard Hole
φ10 (0.39)
L, l
Radiator Upper Support Standard Hole
φ13 (0.51)
M, m
Front Fender Installation Nut
M6 (0.24)

K101733E01