ENGINE COMPARTMENT REFERENCE VALUES (for Hatchback) > THREE-DIMENSIONAL DISTANCE


HINT:
  1. Measure points with the front fender upper protector and engine room side cover removed.
  2. In cases in which only one dimension is given, left and right are symmetrical.
  1. For symbols, capital letters indicate right side of vehicle, small letters indicate left side of vehicle (seen from rear).


Measuring Point Name 
Symbol
Name
Hole Diameter
mm (in.)
A, a
Front Bumper Installation Clip
-
B, b
Headlight Installation Screw
-
C, c
Headlight Installation Screw
-
D, d
Front Fender Installation Bolt
M6 (0.24)
E, e
Front Fender Installation Bolt
M6 (0.24)

K101644E01