FRONT SUSPENSION SYSTEM (for Sedan) > DETAILS



CONSTRUCTION


  1. Front Suspension Support Sub-assembly and Front Coil Spring

    1. The front suspension support sub-assembly has been adopted the construction that the support is connected in one point. As a result, a compact and lightweight construction is offered.



    2. The center axis of the coil spring is slanted toward the outside of the vehicle compared to the center axis of the shock absorber. This reduces the lateral force bearing on the shock absorber piston rod and piston, and prevents increased sliding resistance while helping to maintain riding comfort.


      X105959E01


      Text in Illustration 
      *1
      Front Suspension Support Sub-assembly
      *2
      Strut Mounting Bearing
      *3
      Front Coil Spring
      *4
      Front Spring Bumper
      *5
      Front Shock Absorber Assembly
      -
      -



  2. Front Shock Absorber Assembly



    1. In the front shock absorber assembly, a low-pressure N2 gas sealed type construction is used to suppress cavitations and a multi-leaf type liner control valve is also used to attain the linear damping force characteristics, offering both driving stability and riding comfort.


      X106287E01


      Text in Illustration 
      *1
      Front Shock Absorber Assembly
      *2
      Low-pressure N2 Gas
      *3
      Multi-leaf Type Linear Control Valve
      -
      -

      NOTICE:
      To prevent hazardous conditions, make sure to empty the gas from the shock absorber before discarding an N2 gas sealed shock absorber. For details, refer to the Repair Manual.



    2. The multi-leaf type linear control valve has a structure consisting of several layered leaf valves with different diameter. Through use of the multi-leaf type linear control valve, changes in the damping force are made constant at low piston speeds, thus offering the excellent riding comfort and controllability.


      X101124E01