WIRELESS DOOR LOCK CONTROL SYSTEM (for Sedan) > GENERAL



OUTLINE
  1. This system is a convenient system for locking and unlocking all doors at a distance.

  2. In this system, the door control receiver performs the code identification process and sends the lock or unlock signal to the main body ECU (instrument panel junction block), then the main body ECU (instrument panel junction block) effects the door lock control.

  3. A key-integrated, 3-button (lock, unlock, panic) type door control transmitter is used.

  4. The hazard warning light flashes once when locking, and flashes twice when unlocking, to inform that the operation has been completed.

  5. A panic alarm operation is provided that activates alarms when the "panic" button on the door control transmitter is pressed and held for approximately 0.8 seconds.

    HINT:
    When preparing a new transmitter to replace one that has been lost, it is necessary to register the recognition code. For details, refer to the Service Bulletin.