METER / GAUGE SYSTEM (for Sedan) > DETAILS



SYSTEM CONTROL


  1. Seat Belt Reminder System

    1. A seat belt reminder system is used. If the seat belt is not buckled, the reminder light flashes and the multi buzzer sounds. [The multi buzzer will sound for approximately 30 seconds when the vehicle speed reaches 20 km/h (12 mph) or more.]

    2. When the ignition switch is turned ON, this system determines whether or not the seat belt is buckled depending on whether the signal from the switch in the seat belt buckle is on or off.



    3. The '07 models use the front passenger occupant classification system to detect the presence of an occupant in the front passenger seat. The airbag sensor assembly transmits the resultant detection signal to the meter ECU via the CAN.


      Y112419E02


FUNCTION


  1. Odo/Trip Meter

    1. Pressing the odo/trip selector/reset knob switches between each mode in the following order: odometer to trip meter A to trip meter B.



    2. While the trip meter A or B is displayed, pressing the odo/trip selector/reset knob for 0.8 seconds or longer causes the mileage displayed by the current trip mode to revert to 0.0 km/h (or mile). The trip meter will resume measuring the mileage at the moment the odo/trip selector/reset knob is released.


      Y118355E01



  2. Fuel Gauge

    1. A fuel gauge which displays the amount of remaining fuel in the fuel tank with an 8-segment bar is used.

    2. A remaining fuel amount indicator function is used to blink the No. 1 segment bar when the amount of remaining fuel is lower than the predetermined value. Furthermore, there are 2 patterns of blink cycles depending on the amount of remaining fuel to provide a more accurate remaining fuel warning.

    3. The amount of the remaining fuel is calculated and displayed by the meter ECU. The meter ECU calculates this based on the signal from the fuel sender gauge assembly and the vehicle speed signal from the skid control ECU in accordance with the vehicle conditions such as driving or stopped.



    4. The remaining fuel amount indicator function is activated when the fuel amount data calculated by the meter ECU indicates the amount of remaining fuel has dropped to 15% or less, and causes the No. 1 segment bar to blink in approximately 1.2-second cycles. When the amount of remaining fuel drops to 10% or less, the No. 1 segment bar blinks in approximately 0.6-second cycles.


      Y128899E01


CONSTRUCTION
  1. Optitron Display Type and Analog Display Type

    1. The step-motor is used to actuate the indicators of the speedometer and the tachometer. This has resulted in a thinner indicator movement, thus achieving a lightweight and compact construction.

    2. In the step-motor type, when the power to the combination meter assembly is turned on through the reconnection of the battery terminal, the step-motor initializes once to recognize the zero point of the indicator in relation to the step-motor. However, if the ignition switch is turned to ON after 60 seconds or more have elapsed after the initialization, the step-motor initializes again.


OPERATION


  1. Combination Meter Assembly Illumination Control

    1. As part of the combination meter assembly illumination control, the meter brightness can be adjusted by operating the rheostat knob when the meter ECU has determined that it is nighttime.

    2. The brightness of the meters is fixed to the daytime characteristic when the taillights are off. The brightness is automatically adjusted between the daytime characteristic and nighttime characteristic according to the detection signal provided by the tail relay.

    3. Assuming the maximum brightness to be 1, the meter brightness for the daytime characteristic is fixed at 1/1, and the meter brightness for the nighttime characteristic can be adjusted from 1/8 to 1/50.



    4. The meter ECU controls the combination meter assembly illumination.


      Y112423E01