AIRBAG SYSTEM (for Sedan) > DETAILS |
| SYSTEM CONTROL |
Airbag for Frontal Collision
There are 2 types of airbags for frontal collisions: horn button assembly and instrument panel passenger airbag without door assembly. These airbags deploy simultaneously. The airbags for the driver and the front passenger use dual-stage control.*
This controls the airbag inflating output optimum by judging the extent of the impact from front airbag sensors, and the extent of the impact from airbag sensor assembly, seat position and whether or not the seat belt is fastened.*
*: Models with SRS front passenger airbag

| CONSTRUCTION |
Dual-stage SRS Airbags
To support the dual-stage control, these airbag assemblies contain 2 sets of initiators and propellants. The airbag sensor assembly helps optimize the airbag inflation output by delaying the inflation timing of these initiators.

| *1 | Airbag Sensor Assembly | *2 | Bag |
| *3 | Initiator | *4 | Propellant |
| *a | Compressive Gas | - | - |
Front Airbag Sensor
The electrical (acceleration sensor) type airbag sensor is used for front airbag sensor.
The acceleration sensor is enclosed in the front airbag sensor. Based on the deceleration of the vehicle during a front collision, a distortion is created in the sensor and converted into an electrical signal. Accordingly, the extent of the initial collision can be detected in detail.
Seat Position Airbag Sensor (for Driver)
The seat position airbag sensor which is attached to the seat rail of the driver seat detects the sliding position of the seat. In addition, the shielding plate is installed on this seat rail to make the seat position airbag sensor judge the seat position.
The seat position airbag sensor uses a Hall IC for its sensor and has a magnet portion on its opposite side.

| *1 | Seat Position Airbag Sensor | *2 | Upper Rail |
| *3 | Lower Rail | *4 | Magnet Portion |
| *5 | Hall IC | - | - |
| *a | A-A Cross Section | - | - |
The seat position airbag sensor determines that the seat position is rearward if the sensor is located over the shielding plate, and the seat position is forward if the sensor is not located over the shielding plate.

| *1 | Seat Position Airbag Sensor | - | - |
| *a | Seat position is rearward. | *b | Seat position is forward. |
![]() | Rearward | ![]() | Forward |
Seat Belt Buckle Switch (for Driver)
The seat belt buckle switch which consists of an ejector with a plate, a Hall IC, and 2 magnets is integrated in the front seat inner belt assembly.
The ejector with plate blocks the magnetic flux density between the 2 magnets. The Hall IC outputs this change to the airbag sensor assembly.

| DIAGNOSIS |
If the airbag sensor assembly detects a malfunction in the SRS airbag system, the airbag sensor assembly stores the malfunction data in memory, in addition to illuminating the SRS warning light.
There are 2 types of Diagnostic Trouble Codes (DTCs) of the SRS airbag system: 5-digit and 2-digit.
The 5-digit DTC can be read by connecting the Techstream to DLC3.
The 2-digit DTC can be read through the blinking of the SRS warning light with the SST(09843-18040) connected to the TC and CG terminals of the DLC3.
If the SRS airbag deploys, the airbag sensor assembly will turn on the SRS warning light. However, it is different from the ordinary diagnosis function that a DTC will not be memorized. The SRS warning light can be turned off only by changing the airbag sensor assembly to a new one.
