SEAT ASSEMBLY (for Sedan) > DETAILS |
| FUNCTION |
Front Seat
In order to suppress the backward movement of an occupant during a rear-end collision, a bracket is provided on the front seat frame where the occupant's lumbar is positioned, mitigating the impact of the collision.

| *1 | Front Seat Frame | *2 | Bracket |
| *a | Occupant's movement during a rear-end collision after use of the bracket. | *b | Occupant's movement during a rear-end collision before use of the bracket. |
Seat slide and reclining functions are provided in the driver seat and front passenger seat to enable the seat position to be adjusted to the most comfortable position.
A flat mat structure that consists of springs and straight cables is used in the seat back frame to realize an excellent ride feel.
A vertical lifter is used.
| Seat | Driver | Front Passenger |
| Seat Slide | 240 mm (9.4 in.), 15 mm (0.6 in.) x 16 Steps | |
| Seat Reclining | 52°, 2° x 26 Steps | |
| Vertical Lifter | 45 mm (1.8 in.) | - |

| *a | Vertical Lifter | - | - |
![]() | Seat Slide | ![]() | Seat Reclining |
| CONSTRUCTION |
Front Seat
Seat back pockets are provided on both the driver seat and front passenger seat.

| *1 | Seat Back Pocket | - | - |
Rear Seat
An L-shaped headrest is used to achieve excellent rearward visibility.
An armrest with a cup holder is provided on the 60/40 split folding rear seat.

| *A | Fixed Type | *B | 60/40 Split Folding Type |
| *1 | Headrest | *2 | Armrest |
| *3 | Cup Holder | - | - |
![]() | Pull | ![]() | Move |
Child Restraint System (CRS)
Child Restraint System (CRS) lower anchorages for securing child seats are provided under the rear seat cushion.
3 CRS top tether anchor brackets are provided.

| *1 | CRS Lower Anchorage | *2 | CRS Top Tether Anchor Bracket |