FUEL SYSTEM (for Sedan) > DETAILS



FUNCTION


  1. Fuel Returnless System



    1. This system is used to reduce the evaporative emission. As shown below, integrating the fuel filter, pressure regulator, fuel pump and fuel cutoff valve with module fuel pump enables to discontinue the return of fuel from the engine area and prevent temperature rise inside the fuel tank assembly.


      W104611E01


      Text in Illustration 
      *1
      Fuel Injector Assembly
      *2
      Fuel Delivery Pipe Sub-assembly
      *3
      Pulsation Damper
      *4
      Fuel Cutoff Valve
      *5
      Fuel Filter
      *6
      Fuel Pump
      *7
      Fuel Pressure Regulator Assembly
      *8
      Fuel Tank Assembly
      *9
      Fuel Suction with Pump and Gauge Tube Assembly
      -
      -
      *a
      To Canister
      -
      -


CONSTRUCTION


  1. Fuel Tank Assembly



    1. Low permeability has been realized through the use of the multi-layered plastic fuel tank assembly. This fuel tank assembly consists of six layers using four types of materials.


      W105310E01


      Text in Illustration 
      *1
      High Density Polyethylene (HDPE)
      *2
      Regrind Material
      *3
      Adhesive
      *4
      Ethylene Vinyl Alcohol Copolymer (EVOH)
      *a
      Fuel Tank Assembly Outside
      *b
      Fuel Tank Assembly Inside
      *c
      Fuel Tank Wall Cross Section
      -
      -



  2. Fuel Injector Assembly



    1. The compact 12-hole type fuel injector assemblies are used to ensure the atomization of fuel.


      W104613E01


      Text in Illustration 
      *a
      View from A
      -
      -