FUEL SYSTEM (for Hatchback) > DETAILS



FUNCTION


  1. Fuel Returnless System



    1. This system is used to reduce the evaporative emission. As shown below, integrating the fuel filter, pressure regulator, fuel pump and fuel cutoff valve with module fuel pump enables to discontinue the return of fuel from the engine area and prevent temperature rise inside the fuel tank assembly.


      W104611E01


      Text in Illustration 
      *1
      Fuel Injector Assembly
      *2
      Fuel Delivery Pipe Sub-assembly
      *3
      Pulsation Damper
      *4
      Fuel Cutoff Valve
      *5
      Fuel Filter
      *6
      Fuel Pump
      *7
      Fuel Pressure Regulator Assembly
      *8
      Fuel Tank Assembly
      *9
      Fuel Suction with Pump and Gauge Tube Assembly
      -
      -
      *a
      To Canister
      -
      -


CONSTRUCTION


  1. Fuel Tank Assembly

    1. A multiplex layered plastic fuel tank assembly is used. This fuel tank assembly consists of 6 layers of 4 types of materials.



    2. A fuel drain mark has been provided at the lowest position of the fuel tank assembly. When dismantling (scrapping) the vehicle, drain fuel by drilling a hole at the drain mark.


      W104612E01


      Text in Illustration 
      *1
      High Density Polyethylene (HDPE)
      *2
      Regrind Material
      *3
      Adhesive
      *4
      Ethylene Vinyl Alcohol Copolymer (EVOH)
      *5
      Fuel Drain Mark
      -
      -
      *a
      Fuel Tank Wall Cross Section
      *b
      Fuel Tank Assembly Outside
      *c
      Fuel Tank Assembly Inside
      *d
      View from Bottom Side



  2. Fuel Suction with Pump and Gauge Tube Assembly



    1. A compact fuel pump, fuel filter, pressure regulator and fuel sender gauge are integrated into the fuel pump assembly.


      W104988E01


      Text in Illustration 
      *1
      Fuel Sender Gauge
      *2
      Fuel Filter
      *3
      Fuel Pump
      *4
      Pressure Regulator



  3. Fuel Delivery Pipe Sub-assembly

    1. A pressed steel fuel delivery pipe is used.



    2. Fuel pulsation damper is placed center of the fuel delivery pipe.


      W103949E02


      Text in Illustration 
      *1
      Fuel Delivery Pipe Sub-assembly
      *2
      Fuel Injector Assembly
      *3
      Fuel Delivery Spacer
      *4
      Fuel Pulsation Damper



  4. Fuel Injector Assembly



    1. 12-holes type fuel injector is used. It's possible to atomize fuel, which prevents the fuel from adhering to the intake port walls and reduces exhaust emissions.


      W104989E01


      Text in Illustration 
      *1
      Injector Vibration Insulator
      *2
      Fuel Injector Assembly
      *3
      Fuel Injector O-ring
      *4
      Filter
      *a
      View from A
      -
      -