EMISSION CONTROL SYSTEM (for Sedan) > GENERAL



OUTLINE
  1. Exhaust Emission Control System

    1. 2 Three-Way Catalytic converters (TWCs) are used in the exhaust system.

    2. Based on the signals from the air fuel ratio sensor and oxygen sensor, the ECM controls the fuel injection volume in order to optimize the emissions in the exhaust gas.

  2. Evaporative Emission Control System

    1. The evaporative emission control system prevents the vapor gas that is created in the fuel tank from being released directly into the atmosphere.

    2. The canister stores the vapor gas that has been created in the fuel tank.

    3. The ECM controls the purge VSV in accordance with the driving conditions in order to direct the vapor gas into the engine, where it is burned.

    4. In this system, the ECM checks the evaporative emission leak and outputs Diagnostic Trouble Code (DTC) in the event of a malfunction. An evaporative emission leak check consists of an application of a vacuum pressure to the system and monitoring the changes in the system pressure in order to detect a leakage.

    5. This system consists of the purge VSV, canister, refueling valve, canister pump module and ECM.

    6. The On-board Refueling Vapor Recovery (ORVR) function is provided in the refueling valve.

    7. The canister pressure sensor has been included to the canister pump module.

    8. The canister filter has been provided on the fresh air line. This canister filter is maintenance-free.