INTAKE SYSTEM (for Hatchback) > DETAILS



CONSTRUCTION


  1. Air Cleaner

    1. A nonwoven, full-fabric type air cleaner filter element sub-assembly is used.



    2. An element sub-assembly, which adsorbs the HC that accumulates in the intake system when the engine is stopped, is used in the air cleaner cap in order to reduce evaporative emissions.


      W104615E01


      Text in Illustration 
      *1
      Air Cleaner Cap Sub-assembly
      *2
      Element Sub-assembly
      *3
      Air Cleaner Filter Element Sub-assembly
      -
      -



  2. Throttle with Motor Body Assembly

    1. The linkless type throttle with motor body assembly is used and it realizes excellent throttle control.



    2. A DC motor with excellent response and minimal power consumption is used for the throttle control motor. The ECM performs the duty ratio control of the direction and the amperage of the current that flows to the throttle control motor in order to regulate the opening angle of the throttle valve.


      W103926E01


      Text in Illustration 
      *1
      Throttle Control Motor
      *2
      Throttle Position Sensor
      *3
      Throttle Valve
      *4
      Reduction Gear



  3. Intake Manifold

    1. The intake manifold has been made of plastic to reduce the weight and the amount of heat transferred from the cylinder head sub-assembly. As a result, it has become possible to reduce the intake temperature and improve the intake volumetric efficiency.



    2. A mesh type gasket is used in order to reduce the intake noise.


      W104617E01


      Text in Illustration 
      *1
      Intake Manifold
      *2
      Mesh Type Gasket