COOLING SYSTEM (for Sedan) > GENERAL



OUTLINE
  1. The cooling system is a pressurized, forced-circulation type.

  2. A thermostat with a bypass valve is located on the water inlet housing to maintain suitable temperature distribution in the cooling system.

  3. An aluminum radiator core is used for weight reduction.

  4. The flow of the engine coolant makes a U-turn in the cylinder block sub-assembly to ensure a smooth flow of the engine coolant.

  5. A single cooling fan provides both the cooling and air conditioning performance.



  6. The TOYOTA genuine Super Long Life Coolant (SLLC) is used.


    W104622E01


    Text in Illustration 
    *1
    Water Pump Assembly
    -
    -
    *a
    from Radiator
    *b
    to Radiator
    *c
    from Heater Core
    *d
    to Heater Core
    *e
    to Throttle With Motor Body Assembly
    -
    -


SPECIFICATION
  1. Engine Coolant

    1. TOYOTA genuine Super Long Life Coolant (SLLC) is used. Maintenance interval is as shown in the table below.

    2. SLLC is pre-mixed (50% coolant and 50% deionized water), so no dilution is needed when adding or replacing SLLC in the vehicle.

      Type
      TOYOTA Genuine SLLC or the equivalent*
      Maintenance Intervals
      First Time
      160000 km (100000 miles)
      Subsequent
      Every 80000 km (50000 miles)
      Color
      Pink

      HINT:
      *: Similar high quality ethylene glycol based non-silicate, non-amine, non-nitrite, and non-borate coolant with long-life hybrid organic acid technology. (Coolant with long-life hybrid organic acid technology is a combination of low phosphates and organic acids.) Do not use plain water alone.

  2. Thermostat

    Thermostat Opening Temperature
    80 to 84°C (176 to 183°F)