STARTING SYSTEM (for Sedan) > GENERAL



OUTLINE
  1. A P (conventional planetary reduction) type starter is used.



  2. Cranking hold function is used. Once the ignition switch is turned to the START position, this control operates the starter until the engine starts.


    W104627E01


    Text in Illustration (P Type) 
    *a
    Length
    -
    -


SPECIFICATION

Starter Type
P Type (Conventional Type)
Length
mm (in.)
154 (6.1)
Weight
g (lb)
2800 (6.2)
Rating Voltage
V
12
Rating Output
kW
0.8
Rotating Direction (Viewed from pinion side)
Clockwise

PRECAUTION
  1. Cranking hold function has following safety features.

    1. Once the ignition switch is turned to the START position, this control continues to operate the starter without having to hold the ignition switch in the START position, and stops the starter when the engine starts. This prevents starting failures. However, if the ignition switch is held in the START position, the starter continues to operate.

    2. When the ECM detects a start signal from the ignition switch, this system monitors the engine speed (NE) signal and continues to operate the starter until it determines that the engine has started.