STEERING COLUMN SYSTEM (for Sedan) > DETAILS |
| CONSTRUCTION |
Manual Tilt Mechanism
The manual tilt mechanism mainly consists of a tilt lever, steering column tube attachment, breakaway bracket and tilt steering stopper.
When the manual tilt mechanism is in its locked state, the tilt lever at B position causes the cam of the tilt steering stopper to tighten the steering column tube attachment.
When the manual tilt mechanism is in its free state, the tilt lever at C position causes the cam of the tilt steering stopper to loosen the steering column tube attachment.

| *1 | Steering Column Tube Attachment | *2 | Tilt Lever |
| *3 | Column Tube | *4 | Breakaway Bracket |
| *5 | Tilt Steering Stopper (Cam) | - | - |
| *a | Total 30 mm (1.18 in.) | *b | B (Lock) |
| *c | C (Free) | *d | A-A Cross Section (Free) |
| *e | Narrow | *f | Loosen |
| *g | A-A Cross Section (Lock) | *h | Wide |
| *i | Tighten | - | - |
Energy Absorbing Mechanism
The energy absorbing mechanism in the steering column consists of breakaway bracket, intermediate shaft, pinion shaft, and column tube. The steering column is mounted on the instrument panel reinforcement via a breakaway bracket. The steering column and the steering gear box are connected with a contractile intermediate shaft.
When the steering gear box moves during a collision (primary collision), the intermediate shaft contracts, thus helps reduce the possibility of the steering column and the steering wheel protruding into the cabin.

| *1 | Breakaway Bracket | *2 | Intermediate Shaft Assembly |
| *3 | Main Shaft | - | - |
| *a | Before Collision | *b | After Collision |
![]() | Contract | - | - |
When a collision impact is transmitted to the steering wheel (secondary collision), the steering wheel and the driver's airbag help absorb the impact. In addition, the breakaway bracket separates, and the column tube contracts. At this time, the friction resistance of the sliding portion, which is staked to the column tube, absorbs the energy. This sequential energy absorbing mechanism helps absorb the impact of the secondary collision.

| *1 | Breakaway Bracket | *2 | Capsule (Plastic) |
| *3 | Bolt | *4 | Color |
| *5 | Inner Tube | *6 | Outer Tube |
| *a | Secondary Collision | *b | A-A Cross Section |
| *c | C-C Cross Section | *d | Before Collision |
| *e | After Collision (Maximum Contraction) | - | - |
![]() | Contract | - | - |