LIGHTING SYSTEM (for Hatchback) > DETAILS



FUNCTION OF MAIN COMPONENTS
  1. The main components in the illuminated entry system have the following functions:

    Component
    Function
    Door Courtesy Light Switch Assembly
    Detects whether the doors are open or closed and sends this information to the main body ECU (multiplex network body ECU).
    Lock Position Switch
    Detects whether the doors are locked or unlocked and sends this information to the main body ECU (multiplex network body ECU).
    Door Control Receiver
    Receives the ID code from the transmitter and transmits it to the main body ECU (multiplex network body ECU).
    Main Body ECU (Multiplex Network Body ECU)
    Turns on or off each light using signals from each switch.


FUNCTION
  1. Illuminated Entry Control Function

    1. When any one of the following conditions is satisfied, the illuminated entry system turns on the map light and room light:

      1. Any door is opened.
      2. Any door is unlocked.
      3. All doors are closed and the ignition switch is turned from ON to off.

    2. When any one of the following conditions is satisfied, these lights will fade out (within approximately 1 second):

      1. The lights have remained on for approximately 15 seconds after all doors have been properly closed.
      2. All doors are closed and locked.
      3. All doors are closed and the ignition switch is turned to ON or ACC.

    3. Customize parameters can be configured by means of the customized body electronics system. For details, refer to the Repair Manual.

  2. Battery Saving Function

    1. A battery saving function is used to automatically turn off the map light when the following condition occurs continuously for over 20 minutes:

      1. The key is not in the ignition key cylinder when any door is either ajar or open.