WIPER AND WASHER SYSTEM (for Hatchback) > DETAILS



FUNCTION OF MAIN COMPONENTS
  1. The wiper and washer system consists of the following parts:

    Component
    Function
    Windshield Wiper Switch Assembly
    Outputs the switch position signal to the windshield wiper motor assembly and the rear wiper motor assembly.
    Windshield Wiper Motor and Link Assembly
    Activates the front wiper arm and blade assembly in accordance with position signal of the windshield wiper switch assembly.
    Rear Wiper Motor Assembly
    Activates the rear wiper in accordance with the position signal of the windshield wiper switch assembly.
    Windshield Washer Jar Assembly
    1. Activates the windshield washer motor and pump assembly and rear washer motor and pump assembly in accordance with the signal from the washer switch.
    2. The washer fluid level warning switch assembly transmits a signal to the combination meter assembly when the washer fluid decreases to below a certain level.*
    Combination Meter Assembly
    Receives the operation signal from the washer fluid level warning switch assembly.*

    1. *: Models with washer fluid level warning function


SYSTEM CONTROL


  1. Washer-linked Wiper

    1. When the wiper and washer switch is set to off and the washer switch is turned on for approximately 0.5 seconds or more, the wiper start operating in low speed at the same time as the washer fluid is sprayed.



    2. The wiper operates 3 times in low speed after the washer switch is turned off.


      Y112432E01

  2. Washer Fluid Level Warning Function

    1. When the volume of washer fluid decreases to below a certain level, the washer fluid level warning light of the combination meter turns on to warn the driver.


CONSTRUCTION


  1. Front Wiper Arm and Blade Assembly

    1. The front wiper arm and blade assembly consists of a front wiper arm, front wiper blade, sub arm and swivel.



    2. A pantograph mechanism, in which the sub arm and swivel have been added, is used in the front wiper arm. As a result, the lower portion of the wiper blade will move like it is pushed out around the position where the front wiper arm reverses, expanding the wipe-off area to the bottom corner on the driver side.


      Y111142E01


      Text in Illustration 
      *1
      Front Wiper Arm
      *2
      Sub Arm
      *3
      Swivel
      *4
      Front Wiper Blade
      *a
      When the pantograph mechanism is used.
      *b
      When the pantograph mechanism is not used.
      V100145
      Expanded wipe-off area
      -
      -



  2. Windshield Wiper Motor Assembly



    1. The motor used in the windshield wiper motor assembly has been changed from a generally employed 2-pole motor to a 4-pole motor to reduce the yoke and magnet thickness, achieving a more compact and lightweight form.


      Y111145E01


      Text in Illustration 
      *A
      2-pole Motor
      *B
      4-pole Motor
      *1
      Windshield Wiper Motor
      *2
      Yoke
      *3
      Magnet
      -
      -
      *a
      A-A Cross Section
      -
      -



  3. Windshield Washer Nozzle



    1. A windshield washer nozzle has been mounted on the front wiper arm head to spray washer fluid in the direction from the lower end to the upper end of the front wiper blade so that the minimum area along the wiper blade will be sprayed. Due to this, a reduction in view obstruction when spraying and fluid spread when driving at high speeds has been achieved, meanwhile, good wiping performance with a small amount of washer fluid will also be delivered.


      Y111143E01


      Text in Illustration 
      *1
      Windshield Washer Nozzle
      *2
      Front Wiper Arm Head
      V100145
      Sprayed area
      -
      -



  4. Rear Washer Nozzle



    1. Spray type rear washer nozzles are located on the back door panel.


      Y111144E01


      Text in Illustration 
      *1
      Rear Washer Nozzle
      -
      -
      V100145
      Sprayed area
      -
      -