FEATURES (for Hatchback) > PERFORMANCE



OUTLINE


  1. 1NZ-FE Engine

    1. The 1NZ-FE engine is a 1.5-liter, 16-valve DOHC, in-line 4-cylinder gasoline engine.



    2. This engine uses the Direct Ignition System (DIS), Variable Valve Timing-intelligent (VVT-i) system, and Electronic Throttle Control System-intelligent (ETCS-i). These systems achieve improved engine performance, quietness, fuel economy and clean emission.


      W104600


      Item
      Specification
      No. of Cyls. and Arrangement
      4-cylinder, In-line
      Valve Mechanism
      16-valve DOHC, Chain Drive (with VVT-i)
      Fuel System
      SFI
      Displacement
      1497 cm3 (91.3 cu. in.)
      Max. Output (SAE-NET)*
      79 kW @ 6000 rpm (106 HP @ 6000 rpm)
      Max. Torque (SAE-NET)*
      139 N*m @ 4200 rpm (103 ft.*lbf @ 4200 rpm)

      HINT:
      *: Maximum output and torque rating is determined by revised SAE J1349 procedure.



  2. C50 Manual Transaxle



    1. A C50 5-speed manual transaxle is used.


      V101577


      Item
      Specification
      Gear Ratio
      1st
      3.545
      2nd
      1.904
      3rd
      1.310
      4th
      0.969
      5th
      0.815
      Reverse
      3.250
      Differential Gear Ratio
      3.722



  3. U340E Automatic Transaxle



    1. A U340E 4-speed Super Electronically Controlled Transaxle (Super ECT) is used.


      V101578


      Item
      Specification
      Gear Ratio
      1st
      2.847
      2nd
      1.552
      3rd
      1.000
      4th
      0.700
      Reverse
      2.343
      Differential Gear Ratio*
      4.237

      HINT:
      *: Counter gear ratio included.



  4. Suspension

    1. A MacPherson strut type independent suspension is used for the front.



    2. A torsion-beam type suspension is used for the rear.


      V101573



  5. Steering



    1. An Electric Power Steering (EPS) system is used.


      V101574

  6. Brake

    Item
    Specification
    Front Brake
    Type
    Ventilated Disc
    Rotor size*1
    PE54 (22V)
    255 mm x 22 mm (10.04 in. x 0.87 in.)
    PE57 (22V) *2
    275 mm x 22 mm (10.83 in. x 0.87 in.)
    Rear Brake (for Disc Type)
    Type
    Solid Disc
    Rotor size*1
    259 mm x 9 mm (10.19 in. x 0.35 in.)
    Rear Brake (for Drum Type)
    Type
    Leading-trailing Drum
    Drum Inner Diameter
    200LT
    200 mm (7.87 in.)
    Brake Control System
    ABS with EBD, Brake Assist
    ABS with EBD, Brake Assist, TRAC and VSC

    1. *1: Diameter x Thickness

    HINT:
    *2: S package models except for Puerto Rico and Mexico and RS grade models.