CAN COMMUNICATION SYSTEM (for Hatchback) > DETAILS



DIAGNOSIS
  1. If a malfunction occurs on the CAN communication bus, ECUs that are connected to the CAN communication bus store the Diagnostic Trouble Code (DTC) in memory.

  2. The 5-digit DTCs can be read by connecting the Techstream to DLC3.

  3. DLC3 is equipped with a CAN-H and a CAN-L terminal on the V bus to allow CAN diagnosis. It is possible to determine if there is an open or short in the main wires of the V bus by measuring the resistance value between these terminals.

  4. For details, refer to the Repair Manual.