MULTIPLEX COMMUNICATION SYSTEM (for Hatchback) > GENERAL |
| OUTLINE |
The multiplex communication system uses the 1 communication protocol (CAN) to achieve a streamlined wiring harness configuration.
| Protocol | Outline |
| Controller Area Network (CAN) | The High Speed CAN (HS-CAN) is used for the power train, chassis and body electrical systems. The HS-CAN consists of the V bus. The communication wire uses a twisted-pair wire. The bus line has a high line and a low line. |
| MAIN FEATURES |
Multiplex Communication
Generally speaking, multiplex communication refers to the use of serial communication data that consists of bits and frames in order to exchange information among various ECUs. This allows for a reduction of the amount of wiring on the vehicle. A bit is the basic unit of communication that is used to represent the information. A bit is represented by binary values of "0" or "1". For CAN communication, a differential voltage drive is used to represent the binary values of "0" or "1". This "Differential Voltage Drive" reduces the effects of electrical interference.

The protocol is the rules for establishing data communication.
| Protocol | CAN |
| Communication Speed | 500 kbps* |
| Communication Wire | Twisted-pair Wire |
| Drive Type | Differential Voltage Drive |
| Data Length | 1-8 Byte (Variable) |
A twisted-pair wire is used for CAN communication.
| Communication Wire | Outline |
Twisted-pair Wire![]() | This communication wire is a pair of twisted lines. Communication is driven by applying different voltages to the 2 lines in order to send a single signal. This system, which is called a "Differential Voltage Drive", reduces noise. |
AV Single Wire![]() | This is a lightweight single communication wire that consists of a single core line surrounded by insulation. Voltage is applied to this line in order to drive communication, and this system is called a "Single Wire Voltage Drive". |
