THEFT DETERRENT (for Hatchback) > DETAILS



FUNCTION
  1. The theft deterrent system has the following functions:

    Function
    Outline
    Alarm
    When the theft deterrent system switches to the alarm state, the warning items are operated and the alarm sounds for approximately 57 seconds.
    Theft Warning Indicator Light
    1. When the theft deterrent system switches to the armed preparation state or alarm state, the theft warning indicator light is illuminated to inform the user.
    2. This indicator light is also the engine immobiliser indicator, which blinks when in the engine immobiliser is in the set state.
    Forced Door Lock
    1. The main body ECU (multiplex network body ECU) transmits a door lock signal to all the doors when all of the following conditions are satisfied:
      1. The theft deterrent system is in the alarm state.
      2. There is no key inserted in the ignition key cylinder.
      3. One of the doors has been unlocked.
    2. The function stops when one of the following conditions is met:
      1. All doors are locked.
      2. The warning ends after approximately 57 seconds.
      3. The ignition key is inserted in the ignition key cylinder.
    Panic Control
    When the panic button of the door control transmitter is pressed, the main body ECU (multiplex network body ECU) operates the alarm function.


OPERATION
  1. The states of the theft deterrent system are as follows:

    State
    Description
    Theft Detection
    Disarmed State
    The theft deterrent system has not been set by the user.
    Not available
    Armed Preparation State
    This is the preparation state before the theft deterrent system becomes active (enters the armed state) when the system has been set by the user
    Not available
    Armed State
    The theft deterrent system is active (Theft can be detected).
    Available
    Alarm State
    A theft attempt has been detected and the warning operation activates.
    Available



  2. The theft deterrent system activates as shown in the diagram below when one of items in the table occurs in order to cause the system to enter the respective state.


    Y101685E01


    Condition
    Item
    (1)
    1. There is no ignition key in the ignition key cylinder.
    2. All doors, engine hood and back door are closed.
    3. All doors are locked using the door control transmitter lock button.
    (2)
    The system switches to the armed state when the doors, engine hood and back door all closed and locked, and 30 seconds have elapsed.
    (3)
    1. The system switches to the disarmed state when one of the following conditions is met:
      1. The engine hood, back door or any door is opened.
      2. The engine hood, back door or any door is unlocked.
      3. When the key is inserted into the front door key cylinder.
      4. A terminal is disconnected from the battery and reconnected.
    (4)
    1. The system switches to the alarm state when one of the following conditions is met:
      1. With all doors closed, the engine hood, or back door is opened.
      2. With all doors locked, any door is unlocked by a method other than the mechanical key, door control transmitter.
      3. A terminal is disconnected from the battery and reconnected.
    (5)
    1. The system switches to the disarmed state when one of the following conditions is met:
      1. Any door is unlocked with the door control transmitter.
      2. The back door is opened with the door control transmitter.
      3. The ignition switch is changed to ON or ACC.
    (6)
    The system reverts to the armed state after the alarm time (approximately 57 seconds) elapses.