CLUTCH PEDAL (for Hatchback) > ADJUSTMENT |
| 1. INSPECT AND ADJUST CLUTCH PEDAL HEIGHT (w/o Cruise Control System) |
Pull back the floor carpet.
![]() |
Check that the pedal height is correct.
| *1 | Clutch Pedal Stopper Bolt |
| *2 | Lock Nut (Pedal height adjust point) |
| *a | Pedal height from floor |
If the pedal height is not as specified, adjust it as follows.
Loosen the lock nut and turn the clutch pedal stopper bolt until the correct height is obtained.
Tighten the lock nut.
Install the floor carpet.
| 2. INSPECT AND ADJUST CLUTCH PEDAL HEIGHT (w/ Cruise Control System) |
Pull back the floor carpet.
![]() |
Check that the pedal height is correct.
| *1 | No. 2 Clutch Start Switch Assembly |
| *2 | Lock Nut (Pedal height adjust point) |
| *a | Pedal height from floor |
If the pedal height is not as specified, adjust it as follows.
Disconnect the No. 2 clutch start switch connector.
Loosen the lock nut and turn the No. 2 clutch start switch assembly until the correct height is obtained.
Tighten the lock nut.
Connect the No. 2 clutch start switch connector.
Install the floor carpet.
| 3. INSPECT AND ADJUST PEDAL FREE PLAY AND PUSH ROD PLAY |
![]() |
Check that the pedal free play and push rod play are correct.
| *1 | Push Rod |
| *2 | Lock Nut (Push rod play and free play adjust point) |
| *a | Push rod play |
| *b | Pedal free play |
Depress the pedal until clutch resistance begins to be felt.
Gently depress the pedal until resistance begins to increase a little.
If necessary, adjust the pedal free play and push rod play.
Loosen the lock nut and turn the push rod until the correct free play and push rod play are obtained.
Tighten the lock nut.
After adjusting the pedal free play, check the pedal height.
| 4. INSPECT CLUTCH RELEASE POINT |
![]() |
Check the clutch release point.
| *a | Full stroke end position |
| *b | From pedal stroke end position to release point |
| *c | Release point |
| *d | Pedal stroke |
Pull the parking brake lever and install wheel stoppers.
Start the engine and run it at idle.
Without depressing the clutch pedal, slowly move the shift lever into reverse until the gears come into contact.
Gradually depress the clutch pedal and measure the stroke distance from the point that the gear noise stops (release point) up to the full stroke end position.