Home › Vehicle Interior › HEATING / AIR CONDITIONING › AIR CONDITIONING UNIT (for Sedan)

AIR CONDITIONING UNIT (for Sedan) > REASSEMBLY



1. INSTALL NO. 1 COOLER THERMISTOR


    E107306E04
  1. Install No. 1 cooler thermistor as shown in the illustration.
    Installation Position 
    Part
    Length
    a
    34.3 mm (1.35 in.)
    b
    20.9 mm (0.82 in.)
    c
    50 mm (1.96 in.)
    Text in Illustration 
    *1
    Plastic Case
    *2
    Evaporator
    *a
    from Tank
    *b
    Fixed Part
    *c
    Sensor Part
    *d
    Next to Previous

    NOTICE:
    1. Be sure to insert the sensor only once because reinserting it will not allow it to be firmly secured.
    2. When reusing the evaporator, insert the sensor one row next to the one that was used previously (*d in the illustration).
    3. After inserting the sensor, do not apply excessive force to the wire.
    4. Directly insert the sensor until the edge of the plastic case "*1" comes into contact with the evaporator "*2".



2. INSTALL NO. 1 COOLER EVAPORATOR SUB-ASSEMBLY


I101205

HINT:
If a new cooler evaporator is installed, add compressor oil to the cooler evaporator as follows.

Compressor oil:
ND-OIL8 or the equivalent. Add 40 cc (1.35 fl. oz.)

  1. Install the cooler evaporator.



    I101204
  1. Engage the 4 claws and install the heater case lower.

  1. Install the 3 screws.



    I101199
  1. Engage the cooler thermistor connector.



3. INSTALL COOLER EXPANSION VALVE


I101203
  1. Apply sufficient compressor oil (ND-OIL8) to 2 new O-rings and the fitting surface of the cooler expansion valve.

    Compressor oil:
    ND-OIL8 or the equivalent

  1. Install the 2 O-rings onto the cooler evaporator.

  1. Using a hexagon wrench 4, install the cooler expansion valve with the 2 hexagon bolts.

    Torque:
    3.5 N*m{ 36 kgf*cm , 31 in.*lbf }



4. INSTALL HEATER RADIATOR UNIT SUB-ASSEMBLY


I101202
  1. Install the heater radiator unit onto the air conditioner radiator assembly.



    I101620
  1. Engage the 3 clips and install the clamp.



5. INSTALL NO. 2 AIR DUCT


I101196
  1. Engage the 3 claws and install the air duct.



6. INSTALL NO. 1 AIR DUCT


I101195
  1. Engage the 3 claws and install the air duct.



7. INSTALL AIR MIX DAMPER CONTROL CABLE SUB-ASSEMBLY


I101193
  1. Engage the claw and install the air mix damper control cable.



8. INSTALL DEFROSTER DAMPER CONTROL CABLE SUB-ASSEMBLY


I101194
  1. Engage the claw and install the defroster damper control cable.