Home › Suspension › TIRE / WHEEL › TIRE AND WHEEL SYSTEM (for Hatchback)

TIRE AND WHEEL SYSTEM (for Hatchback) > INSPECTION



1. INSPECT TIRES
  1. Check the tires for wear and proper inflation pressure.

    Cold Tire Inflation Pressure 
    Tire Size
    Front
    kPa (kgf/cm2, psi)
    Rear
    kPa (kgf/cm2, psi)
    P175/65R15 84H
    230 (2.3, 33)
    230 (2.3, 33)
    P195/50R16 83V
    220 (2.2, 32)
    200 (2.0, 29)
    185/60R15 84H
    220 (2.2, 32)
    220 (2.2, 32)



    C164558
  1. Using a dial indicator, check the tire runout.

    Tire Runout:
    Vertical
    1.4 mm (0.0551 in.) or less
    Lateral
    2.0 mm (0.0787 in.) or less



2. ROTATE TIRES


C288825E01

HINT:
Rotate the tires, as shown in the illustration.

Text in Illustration 
*A
for North America
*B
except North America
V100136
Front of the Vehicle

Torque:
103 N*m{ 1050 kgf*cm , 76 ft.*lbf }



3. INSPECT WHEEL BALANCE


  1. Inspect and adjust the off-the-car balance.



      C144019
    1. Steel wheel:

      Maximum imbalance:
      8.0 g (0.0176 lb)



    2. C286974E01
    3. Others (Non-steel wheel):

      Maximum imbalance:
      8.0 g (0.0176 lb)

      NOTICE:
      1. Use a cleaning detergent to remove dirt, oil and water from the surface where the balance weight is to be adhered.
      2. Do not touch the adhesive part of the tape.
      3. Adhere a sticking type balance weight to the flat surface (A) shown in the illustration.

        Width (A):
        25 mm (0.984 in.)

      4. Push the balance weight securely with your finger to adhere it to the desired position.
      5. Do not reuse the balance weight.
      6. Use the TOYOTA genuine sticking type balance weights.

      HINT:
      The inner side balance weight should be installed by clipping it to the rim.

  1. If required, inspect and adjust the on-the-car balance.

    Maximum imbalance:
    8.0 g (0.0176 lb)



4. INSPECT FRONT AXLE HUB BEARING
(Click here)


5. INSPECT REAR AXLE HUB BEARING
(Click here)