PROPORTIONING VALVE (for Sedan) > ON-VEHICLE INSPECTION |
| 1. INSPECT PROPORTIONING VALVE (w/o ABS) |
Remove the bleeder plug from the front brake caliper and rear wheel cylinder.

Install SST and then bleed the air.
Raise the front brake caliper pressure and inspect the rear wheel cylinder pressure.
| Front Brake Caliper Pressure | Rear Wheel Cylinder Pressure |
| 1,500 kPa (15.3 kgf/cm2, 218 psi) | 1,500 kPa (15.3 kgf/cm2, 218 psi) |
| 5,000 kPa (51.0 kgf/cm2, 725 psi) | 2,350 kPa (24.0 kgf/cm2, 341 psi) |
| 8,000 kPa (81.6 kgf/cm2, 1,160 psi) | 3,100 kPa (31.6 kgf/cm2, 450 psi) |
Remove SST.
Install the bleeder plug onto the front brake caliper and rear wheel cylinder.
Bleed the brake fluid (Click here).
Check the brake fluid leakage.