PROPORTIONING VALVE (for Hatchback) > ON-VEHICLE INSPECTION |
| 1. INSPECT PROPORTIONING VALVE |
Remove the bleeder plug from the front brake caliper and rear wheel cylinder.

Install SST and then bleed the air.
Raise the front brake caliper pressure and inspect the rear wheel cylinder pressure.
| Front Brake Caliper Pressure | Rear Wheel Cylinder Pressure |
| 1500 kPa (15.3 kgf/cm2, 218 psi) | 1500 kPa (15.3 kgf/cm2, 218 psi) |
| 5000 kPa (51.0 kgf/cm2, 725 psi) | 2350 kPa (24.0 kgf/cm2, 341 psi) |
| 8000 kPa (81.6 kgf/cm2, 1160 psi) | 3100 kPa (31.6 kgf/cm2, 450 psi) |
Remove SST.
Install the bleeder plug onto the front brake caliper and rear wheel cylinder.
Bleed the brake fluid .
Check the brake fluid leakage.