FRONT BRAKE (for Hatchback) > INSPECTION |
| 1. INSPECT BRAKE CYLINDER AND PISTON |
Check the cylinder bore and piston for rust and scoring.
If necessary, replace the disc brake cylinder and piston.
| 2. INSPECT PAD LINING THICKNESS |
![]() |
Using a ruler, measure the pad lining thickness.
| *1 | Ruler |
| 3. INSPECT FRONT DISC BRAKE PAD SUPPORT PLATE |
Make sure that the disc brake pad supports have sufficient rebound, that there is no deformation, cracking or wear, and that all rust and dirt are removed.
If necessary, replace the disc brake pad support plate.
| 4. INSPECT DISC THICKNESS |
![]() |
Using a micrometer, measure the disc thickness.
| *1 | Micrometer |
| 5. INSPECT DISC RUNOUT |
Check the bearing play in the axial direction and check for the axle hub runout .
Tighten the disc with the 4 nuts.
![]() |
Using a dial indicator, measure the disc runout 10 mm (0.394 in.) away from the outer edge of the front disc.
| *1 | Dial Indicator |