Home › Brake › BRAKE (FRONT) › FRONT BRAKE (for Hatchback)

FRONT BRAKE (for Hatchback) > DISASSEMBLY



1. REMOVE CYLINDER BOOT


    C116883E05
  1. Using a screwdriver with its tip wrapped in protective tape, remove the set ring and cylinder boot from the disc brake cylinder.
    Text in Illustration 
    *1
    Protective Tape

    NOTICE:
    Be careful not to damage the brake piston or cylinder.



2. REMOVE FRONT DISC BRAKE PISTON


G031605E03
  1. Place a piece of cloth between the piston and disc brake cylinder.
    Text in Illustration 
    *1
    Cloth

  1. Apply compressed air to remove the piston from the disc brake cylinder.

    CAUTION:
    Do not place your fingers in front of the piston when applying compressed air.

    NOTICE:
    Do not spatter the brake fluid.



3. REMOVE PISTON SEAL


    C116884E05
  1. Using a screwdriver with its tip wrapped in protective tape, remove the piston seal from the disc brake cylinder.
    Text in Illustration 
    *1
    Protective Tape

    NOTICE:
    Do not damage the inner surface or piston seal groove of the cylinder.



4. REMOVE FRONT DISC BRAKE BLEEDER PLUG CAP


5. REMOVE FRONT DISC BRAKE BLEEDER PLUG