FRONT DOOR (for Sedan) > ADJUSTMENT |

| 1. INSPECT FRONT DOOR |
Check that the clearance measurements are within the standard ranges.

| Area | Measurement | Area | Measurement |
| A | 2.5 to 5.5 mm (0.098 to 0.217 in.) | E | 3.3 to 6.3 mm (0.130 to 0.248 in.) |
| B | -1.5 to 1.5 mm (-0.059 to 0.059 in.) | F | -1.5 to 1.5 mm (-0.059 to 0.059 in.) |
| C | 3.2 to 6.2 mm (0.126 to 0.244 in.) | G | 4.2 to 7.2 mm (0.165 to 0.283 in.) |
| D | 1.3 to 4.3 mm (0.051 to 0.169 in.) | - | - |
| 2. ADJUST FRONT DOOR |
Disconnect the cable from the negative battery terminal.
Wait for at least 90 seconds after disconnecting the cable to prevent the airbag from working.
![]() |
Using SST, adjust the door horizontally and vertically by loosening the body side hinge bolts.
Tighten the body side hinge bolts after the adjustment.
![]() |
Adjust the door horizontally and vertically by loosening the door side hinge bolts.
Tighten the door side hinge bolts after the adjustment.
![]() |
Using "Torx" socket wrench T40, adjust the striker position by slightly loosening the striker mounting screws and hitting the striker with a plastic-faced hammer.
Using "Torx" socket wrench T40, tighten the striker mounting screws after the adjustment.
Connect the cable to the negative battery terminal.