FRONT BRAKE (for Hatchback) > INSTALLATION |
| 1. INSTALL FRONT DISC |
![]() |
Align the matchmarks of the disc and axle hub and install the disc.
| *a | Matchmark |
| 2. INSTALL FRONT DISC BRAKE CYLINDER MOUNTING |
Install the disc brake cylinder mounting onto the steering knuckle with the 2 bolts.
| 3. INSTALL FRONT DISC BRAKE BUSH DUST BOOT |
![]() |
Apply a light layer of lithium soap base glycol grease to the entire circumference of 2 new dust boots as shown in the illustration.
| *1 | Lithium Soap Base Glycol Grease |
Install the 2 dust boots onto the disc brake cylinder mounting.
| 4. INSTALL FRONT DISC BRAKE CYLINDER SLIDE PIN |
Apply a light layer of lithium soap base glycol grease to the entire circumference of the slide pin (lower) as shown in the illustration.
Install the slide bush onto the slide pin (lower).
![]() |
Apply a light layer of lithium soap base glycol grease to the entire circumference of the slide pins, as shown in the illustration.
| *1 | Lithium Soap Base Glycol Grease |
| *2 | Slide Pin (Upper) |
| *3 | Slide Pin (Lower) |
| *4 | Slide bush |
Install the slide pin (upper) and slide pin (lower) onto the cylinder mounting.
| 5. INSTALL FRONT DISC BRAKE PAD SUPPORT PLATE |
![]() |
Install the 4 disc brake pad support plates onto the disc brake cylinder mounting.
| *1 | No. 1 Front Disc Brake Pad Support Plate |
| *2 | No. 2 Front Disc Brake Pad Support Plate |
| 6. INSTALL FRONT ANTI SQUEAL SHIM KIT |
![]() |
Apply disc brake grease to both sides of each No. 1 anti squeal shim.
| *1 | Disc Brake Grease |
![]() |
Install the 4 anti squeal shims onto each brake pad.
| *1 | Pad Wear Indicator Plate |
| *2 | No. 1 Anti Squeal Shim |
| *3 | No. 2 Anti Squeal Shim |
Install the pad wear indicator plates onto the upper side of the brake pads.
| 7. INSTALL FRONT DISC BRAKE PAD KIT |
Install the 2 disc brake pads onto the disc brake cylinder mounting.
| 8. INSTALL DISC BRAKE CYLINDER ASSEMBLY |
Hold the slide pin with a wrench and install the disc brake cylinder onto the disc brake cylinder mounting with the 2 bolts.
| 9. CONNECT FRONT FLEXIBLE HOSE |
Connect the flexible hose with a new union bolt and a new gasket.
| 10. BLEED BRAKE LINE |
| 11. BLEED CLUTCH LINE (for Manual Transaxle) |
| 12. INSTALL FRONT WHEEL |