Home › Brake › BRAKE (FRONT) › FRONT BRAKE (for Hatchback)

FRONT BRAKE (for Hatchback) > REMOVAL



1. REMOVE FRONT WHEEL


2. DRAIN BRAKE FLUID

NOTICE:
Immediately wash off any brake fluid that comes into contact with any painted surfaces.



3. DISCONNECT FRONT FLEXIBLE HOSE


    C234690
  1. Remove the union bolt and gasket and separate the flexible hose from the disc brake cylinder.



4. REMOVE DISC BRAKE CYLINDER ASSEMBLY


    C234691
  1. Hold the slide pin with a wrench, remove the 2 bolts and remove the disc brake cylinder.



5. REMOVE FRONT DISC BRAKE PAD KIT


    C234692
  1. Remove the disc brake pad kit from the disc brake cylinder mounting.



6. REMOVE FRONT ANTI SQUEAL SHIM KIT


    C234653E01
  1. Remove the No. 1 anti squeal shim and No. 2 anti squeal shim from each brake pad.
    Text in Illustration 
    *1
    Pad Wear Indicator Plate
    *2
    No. 1 Anti Squeal Shim
    *3
    No. 2 Anti Squeal Shim
    *4
    Front Disc Brake Pad

  1. Remove the pad wear indicator plate from each brake pad.



7. REMOVE FRONT DISC BRAKE PAD SUPPORT PLATE


    C234693E01
  1. Remove the 4 disc brake pad support plates from the disc brake cylinder mounting.
    Text in Illustration 
    *1
    No. 1 Front Disc Brake Pad Support Plate
    *2
    No. 2 Front Disc Brake Pad Support Plate

    NOTICE:
    Each pad support plate has a different shape. Be sure to put an identification mark on each pad support plate so that they can be installed in their original position.



8. REMOVE FRONT DISC BRAKE CYLINDER SLIDE PIN


    C108928E01
  1. Remove the slide pin (upper) and slide pin (lower) from the disc brake cylinder mounting.
    Text in Illustration 
    *1
    Slide Pin (Upper)
    *2
    Slide Pin (Lower)



9. REMOVE FRONT DISC BRAKE CYLINDER SLIDE BUSH


    C108929E07
  1. Using a screwdriver with its tip wrapped in protective tape, remove the slide bush from the slide pin (lower).
    Text in Illustration 
    *1
    Protective Tape
    *2
    Slide Bush
    *3
    Slide Pin (Lower)

    NOTICE:
    Be careful not to damage the slide pin.



10. REMOVE FRONT DISC BRAKE BUSH DUST BOOT


    C108930
  1. Remove the 2 dust boots from the disc brake cylinder mounting.



11. REMOVE FRONT DISC BRAKE CYLINDER MOUNTING


    C108931
  1. Remove the 2 bolts and disc brake cylinder mounting from the steering knuckle.



12. REMOVE FRONT DISC


    C108932E02
  1. Place matchmarks on the disc and axle hub and remove the disc.
    Text in Illustration 
    *a
    Matchmark