SFI SYSTEM (for Sedan) > DTC CHECK / CLEAR |
| CHECK DTC |
Connect the Techstream to the DLC3.
Turn the ignition switch to ON.
Turn the Techstream on.
Enter the following menus: Powertrain / Engine and ECT / Trouble Codes.
Check DTCs and freeze frame data, and then write them down.
Check the details of DTCs (Click here).
| CLEAR DTC |
Connect the Techstream to the DLC3.
Turn the ignition switch to ON.
Turn the Techstream on.
Enter the following menus: Powertrain / Engine and ECT / Trouble Codes.
Clear DTCs.
| CLEAR DTC (Without using Techstream) |
Perform either of the following operations:
Disconnect the cable from the negative battery terminal for more than 1 minute.
Remove the EFI and ETCS fuses from the engine room relay block located inside the engine compartment for more than 1 minute.