SFI SYSTEM (for Hatchback) > CHECKING MONITOR STATUS |
| PERFORM MONITOR DRIVE PATTERN |
Connect the Techstream to the DLC3.
Turn the ignition switch to ON and turn the Techstream on.
Clear DTCs (Click here).
Operate the vehicle in accordance with the applicable drive pattern described in Readiness Monitor Drive Pattern (Click here). Do not turn the ignition switch off.
| ACCESS MONITOR RESULT |
Enter the following menus: Powertrain / Engine and ECT / Monitor / Current Monitor / Result.
Confirm the monitor status for each component.
Display the test results and test values for a monitor by selecting the icon in the Details column for that monitor.
| CHECK COMPONENT STATUS |
Compare the test value with the minimum test limit (Min Limit) and maximum test limit (Max Limit).
If the test value is between the minimum and maximum test limits, the component is functioning normally. If not, the component is malfunctioning. The test value is usually not near the test limits. If the test value is on the borderline of the test limits, the component is likely to malfunction in the near future.
| MONITOR RESULT INFORMATION |