CURTAIN SHIELD AIRBAG ASSEMBLY (for Hatchback 3 Door) > INSTALLATION |
| 1. INSTALL CURTAIN SHIELD AIRBAG ASSEMBLY |
Check that the ignition switch is off.
Check that the cable is disconnected from the negative (-) battery terminal.
![]() |
Install 6 new clips, 6 new spacers and the curtain shield airbag assembly as shown in the illustration.
| *1 | Clip |
| *2 | Pin |
| *3 | Spacer |
| *4 | Airbag |
| *5 | Body Side |
![]() |
Engage hook A by inserting it while sliding in the direction shown in the illustration, then engage hook B by inserting it from the direction shown in the illustration, and temporarily install the curtain shield airbag RH with the bolt.
| *1 | Hook A |
| *2 | Hook B |
![]() |
Push in the 6 pins to install the 6 clips and the curtain shield airbag assembly to the body panel as shown in the illustration.
| *1 | Pin |
| *2 | Clip |
| *3 | Airbag |
| *4 | Body Panel |
Mark the clips.
Tighten the bolt.
![]() |
Connect the airbag connector.
| *1 | Locking Button |
Push in the locking button.
| 2. INSTALL ROOF HEADLINING ASSEMBLY |
| 3. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL |
| 4. INSPECT SRS WARNING LIGHT |